Constitutive Model and Experimental Study of Stud Steel-Shotcrete Interface Bond-Slip in Mining Method Tunnel Initial Support
Journal Title: Urban Mass Transit - Year 2024, Vol 27, Issue 8
Abstract
Objective It is aimed to elucidate the constitutive relationship of bond-slip at the interface between stud steel and shotcrete in the initial support of mining method tunnel. Method Four different working conditions are set by varying the length, diameter, and arrangement of the studs. Push-out tests are conducted on steel-shotcrete short columns with studs on web plate, analyzing failure modes, load-slip characteristics and bearing capacity. Result & Conclusion The failure modes of stud specimens are affected by the number and strength of studs, categorized into tensile splitting and bursting failure. The typical average bond strength-relative slip curve can be divided into four stages: no slip, ascending curve, descending curve, and horizontal residual stage. Laboratory tests demonstrate that the diameter and arrangement of the studs are primary factors affecting the bearing capacity. A bond-slip constitutive model for the interface between stud steel and shotcrete is established based on stress mechanism, validated through both laboratory tests and numerical simulations, showing high accuracy. The research results can provide theoretical support for the design of steel and shotcrete support structures of mining method tunnels.
Authors and Affiliations
Zonglin YANG, Shiwen XU, Zhikai LU, Junfu LU, Minrui LI
Keywords
Related Articles
- EP ID EP742702
- DOI 10.16037/j.1007-869x.2024.08.031
- Views 33
- Downloads 0
Influence Analysis of Super-large Diameter Steel Pipe Pile Resonance-free Method Construction on Surrounding Soil Deformation
Objective The high-frequency resonance-free method is renowned for its high efficiency and low environmental impact. To further investigate the influence of constructing super-large diameter steel pipe pile with this met...
Selection and Heat Dissipation Analysis of Regenerative Braking Energy Absorption Device in Urban Rail Transit Depot
[Objective] The regenerative braking energy absorption resistance in urban rail transit depot has a large heat dissipation. In order to effectively solve the problem, it is necessary to select the right type of regenerat...
Research on Fuzhou Metropolitan Area City Railway Network Architecture
Objective To respond to the development requirements of Fuzhou Metropolitan Area, it is necessary to construct an efficient city (suburban) railway network that seamlessly integrates with other rail transit modes. The go...
Simulation and Optimization of Metro Train Braking Rate under the Timing Condition
［Objective］ With the proposal of a green and low-carbon development goal for urban rail transit in China, metro is facing a daily increasing pressure of energy saving and emission reduction. Since traction consumes the...
Sensitivity Analysis of Design Parameters for Suspended Monorail Single-ribbed Arch Bridge
[Objective] As there are few case studies on suspended monorail single-ribbed arch bridge, it is necessary to analyze the sensitivity of different design parameters to better instruct the design and construction of the b...