Construction of Rectangular Window Linear Time Verient Filter for Noise Concellation Using FRFT
Journal Title: International Journal of Electronics Communication and Computer Technology - Year 2014, Vol 4, Issue 1
Abstract
The Direct sequence spread spectrum concepts are important for achieving better performance of communication systems. The suppression of interference noise present in the spread spectrum communication systems is essential for achieving the specified system performance. Most of the existing interference suppression methods do not perform well for non stationary signals in the present paper Interference suppression schemes based on orthogonal time-frequency decomposition, wavelets and arbitrary time-frequency signals have been considered. These methods often reduce interference substantially; however their performance depends on mathematical modeling for minor changes in interference characteristics such as the center frequency. By using rectangular window methods for fractional Fourier transform with blind interference excision scheme appears promising for mitigating time-frequency induced interference. Simulations of narrowband interference are compared with the performance of the linear time variant filter. The filter performance is evaluated with existing fractional Fourier transform (FRFT) techniques for different Jamming-to-Signal Ratios (JSR) starting from 20 dB to 100 dB in steps of 10 dB. The Simulation results of the proposed synthetic model algorithm shows that there is considerable improvement in Signal-to-Noise Ratio (SNR) and better interference suppression with rectangular FRFT filtering of the DS-SS signal.
Authors and Affiliations
N. Murugendrappa| Department of electronics, Jnana Sahyadri, Kuvempu University, Shankaraghatta Shivmogga,India, Dr. A. G Ananth| RV center for Cognitive Technologies RVCE Campus, Bangalore Karanataka ,India
Keywords
Related Articles
- EP ID EP8383
- DOI -
- Views 434
- Downloads 25
Conversion of an 8-bit to a 16-bit Soft-core RISC Processor
The demand for 8-bit processors nowadays is still going strong despite efforts by manufacturers in producing higher end microcontroller solutions to the mass market. Low-end processor offers a simple, low-cost and fast s...
Design and Verification of Serial Peripheral Interface using OVM
The main objective of the work is to design SPI Master Core using Verilog and verify the code using Open Verification Methodology. Serial Peripheral Interface (SPI) is an interface that facilitates the transfer of synchr...
Implementation of Electronic Voting Machine with Multiple Preferences and Priority
Traditional paper based voting procedure was very long and time-consuming process and very much prone to errors. Polling by Electronic Voting Machine (EVM) is a simple, safe and secure method that takes minimum of time....
An Error Notification Method for a High Speed Serial Communication on FPGA
In parallel communication the cost as well as complexity of the system increases due to simultaneous transmission of data bits on multiple wires. Serial communication alleviates this drawback and emerges as effective...
License Plate Recognition System based on Image Processing Using Labview
A License plate recognition (LPR) system is one kind of an intelligent transport system and is of considerable interest because of its potential applications in highway electronic toll collection and traffic monitoring s...