Design, construction and characterization of pneumatic system for measurement of roughness
Journal Title: TecnoLógicas - Year 2015, Vol 18, Issue 35
Abstract
This article aims to present the results obtained from the design, construction and characterization of a pneumatic flapper-nozzle amplifier, employed in the measurement of average surface roughness. In the construction of the sensor, low cost materials were used and most pieces were obtained by machining. The data acquisition was performed through PC, using an Arduino interface board. The nonlinear mathematical model of the sensor is based on equations of perfect gas flow through an orifice and the continuity law for a control volume. The characterization of physical parameters obtained through laboratory techniques based on the transient response of the gas pressure in the pressurization and depressurization processes of constant volume chambers, using computational tools for adjusting experimental curves. The validation of the model was based on the specifications of transient response that presents a dynamic system for a step input. For the measurement of the roughness, the mathematical model of average roughness, Ra, was used, and the measured data by the sensor were obtained in sandpapers from P1000 to P2000 size, with reference for validation values of average roughness indicated by the FEPA standard.
Authors and Affiliations
Germán A. Bacca-Bastidas, Iván Vásquez-Valencia, Julián Pérez-Ordóñez
Keywords
Related Articles
- EP ID EP402304
- DOI 10.22430/22565337.186
- Views 135
- Downloads 0
Production and characterization of composite materials with epoxy resin matrices reinforced with tire rubber and magnetite in different proportions
This work describes the production and magnetic characterization of a compound base on epoxy resin and powdered rubber reinforced with magnetite (𝐹𝑒3𝑂4) poder. Also it is presented the análisis carried out on the compone...
A phantom-based study for assessing the error and uncertainty of a neuronavigation system
This document describes a calibration protocol with the intention to introduce a guide to standardize the metrological vocabulary among manufacturers of image-guided surgery systems. Two stages were developed to...
Transmission network expansion planning considering weighted transmission loading relief nodal indexes
This paper presents a model and a solution approach for the transmission network expansion planning (TNEP) problem that integrates security constraints given by weighted transmission loading relief (WTLR) indexes. Such i...
Spectral analysis through filter banks aplied to preprocessing oriented to thresholding of pulse oximetry signal
The pulse oximetry signal (SPO2), allows the calculation of the oxygen saturation level in the blood, and it is acquired over the index finger of the patient. Under normal conditions, the variations in SPO2 have correlat...
Performance of clustering techniques for solving multi depot vehicle routing problem
The vehicle routing problem considering multiple depots is classified as NP-hard. MDVRP determines simultaneously the routes of a set of vehicles and aims to meet a set of clients with a known demand. The objective funct...