Design & Implementation of Fuzzy Parallel Distributed Compensation Controller for Magnetic Levitation System
Journal Title: IOSR Journals (IOSR Journal of Electrical and Electronics Engineering) - Year 2017, Vol 12, Issue 4
Abstract
This study applies technique parallel distributed compensation (PDC) for position control of a Magnetic levitation system. PDC method is based on nonlinear Takagi-Sugeno (T-S) fuzzy model. It is shown that this technique can be successfully used to stabilize any chosen operating point of the system. All derived results are validated by experimental and computer simulation of a nonlinear mathematical model of the system. The controllers which introduced have big range for control the system.
Authors and Affiliations
Milad Gholami, Zohreh Alzahra Sanai Dashti, Masoud Hajimani
Keywords
Related Articles
- EP ID EP388218
- DOI 10.9790/1676-1204022028.
- Views 124
- Downloads 0
Performance Analysis of Amorphous Photovoltaic Module Technology in Laâyoune -Morocco
The main objective of this work is to study the performance of photovoltaic module based on silicon amorphous technology (a-si) installed on the roof of a building 10 m high of ESTL (Morocco). The system was monitored be...
Design of the Pulse Oximetry Measurement Circuit and Its Sensing System Based On CMOS
The pulse oximetry circuit and its sensing system is designed based on the standard CMOS technology of 0.18um. The reflection oxygen sensor is used to collect the pulse oximeter signal of human body, then the collected p...
Adaptation of Solar Photovoltaic Technology in Bache State, Nigeria: Problems and Prospects
Rapid technological advancement in the economically quick growing countries such as India, China Malaysia and their contemporaries are indeed beyond reasonable doubt related to their efficient and reliable sources of ele...
A Detuning Study of a Miniaturized PIFA Antenna inside the Human Thorax Model
Nowadays, the increasing demand for implantable medical devices (IMD) has required the design of efficient invasive antennas. However, designing an antenna operable in a biological layer is actually an extremely challeng...
Influence of Optimal Network Reconfiguration of Electric Power Distribution Feeders on Power Loss Minimization: A Comprehensive Review
The aim of reconfiguring the electric power distribution network under normal operating conditions is to reduce the total active power losses of the network or to balance the load of the system’s feeders which is an impo...