Design of Airship for Aerial Surveillance and Communication Using Knowledge Based Engineering
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 1
Abstract
Design and development of Airships is receiving attention over past 5 years. The present paper deals with the design of an airship that could be hovered for long periods to provide aerial survey and also to act as an intermediate link between two commutation stations operating on low range communication Systems and interruptions in data acquisition. Existing designs and fabrication techniques were first reviewed. Then, the design was carried out based on the requirements. The emphasis of design was laid on minimum operation and low maintenance cost design. The model was then designed in CATIA and analyzed in ANSYS. The results showed good aerodynamic performance of the airship. The airship prototype was made using 3D printing.
Authors and Affiliations
M. GANESH, SAI KUMAR A
Keywords
Related Articles
- EP ID EP278669
- DOI 10.24247/ijmperdfeb20183
- Views 81
- Downloads 0
Operational Study of Circulating Fluidized Bed Steam Generator
The paper aims at studying the operation of a lignite fired Circulating Fluidized bed Combustion steam generatorof 250 MW capacity located at NeyveliinTamilnadu in South India. Circulating fluidized bed combustion(CFBC)...
EXPERIMENTAL EVALUATION OF PERFORMANCE OF AIR-CONDITIONING COMPRESSOR DUE TO AL2O3 NANOPARTICLES IN LUBRICATING OIL
Nanoparticles are being widely used in recent years, due to their advantages. Addition of nanoparticles leads to significant change in thermal properties of a fluid. A new engineering medium, called nanofluid attracted a...
Immobilized PAni-TiO2 Nano-Photocatalyst Modeling for Photocatalytic Degradation of 1, 2-Dichloroethane using Response Surface Methodology (RSM) and Artificial Neural Network (ANN)
Heterogeneous photocatalytic degradation as an advanced oxidation process (AOP) is a complicated process, because many independent influential parameters can affect degradation efficiency as the response of the system. T...
An Effect of Wall Corner Radius of Punch on the Features of the Hexagonal Cup Fabricated by the Deep Drawing Process
This work aims to study the effect of different deep drawing process parameters on the distribution of strain and thickness in deep drawing operation, such as wall corner radius of punch, the thickness of the sheet, and...
Experimental Investigation of Exhaust Heat Recovery in Petrol Engine using Nano Enhanced PCM
About thirty percentage of the heat released during combustion process is carried away by the exhaust gas formed inside the internal combustion engine. This waste heat can be extracted through exhaust gas recirculation s...