Determination of frequency-controlled induction motor rotor’s equivalent thermal circuit thermal resistance
Journal Title: Вісник Національного технічного університету "ХПІ". Серія: Проблеми удосконалювання електричних машин і апаратів. Теорія і практика - Year 2015, Vol 42, Issue 1151
Abstract
The necessity of frequency-controlled induction motor study thermal state is determined by frequent failure of these motors due to overheating of the stator windings, especially in non-stationary modes. The determining method of frequency-controlled induction motor rotor’s winding thermal resistance, which are part of the frequency-controlled induction motor equivalent thermal circuit dynamic parameters are detailed considered in the paper. The mathematical model obtained based on the given thermal equivalent circuit used for the frequency-controlled induction motor thermal state research. The efficiency and adequacy of the obtained frequency-controlled induction motor thermal state mathematical model are experimentally confirmed. The research results in previously published papers are detail considered [1-6].The paper material complements these papers and makes it easier for induction motor design professionals to study and use the given method.
Authors and Affiliations
A. N. Petrenko, V. P. Shajda, N. Ya. Petrenko
Keywords
Related Articles
- EP ID EP408845
- DOI -
- Views 129
- Downloads 0
Requirements for contact materials of switching devices
It is proposed to move from use in the construction of high-current electrical apparatus of copper alloys as electrical contact materials to powder materials. An analysis of the composition of the powder material is pres...
Analysis of the thermal state of various modifications of the mining traction motor DC type ДТН-45/27
Purpose. Studies were made of the possibilities of increasing the hourly power of traction motors of direct current type ДТН-45/27. Methodology. Physical simulation of the DC motor was made to determine the influence of...
Effect of frequency on distribution of current density and on heating of printed boards
Introduction. The article deals with the distribution of the current density and the heating of the conductors of the printed circuit board, depending on the frequency of the source at a fixed value of the current. In th...
Development and research of system of automatic control of electric traction
Were developed by structural schemes of automatic control system of traction electric drive based on a synchronous motor with permanent magnets, the use of which allows you to control the motion of electric contact locom...
Spectral analysis of measured voltage on pick-up coil of eddy current sensor
Spectral analysis of measured voltage on pick-up coil of eddy current sensor in case of noise presence in a signal is made. Main components of noise that influence the measured voltage are found. Here such components are...