Determination of Optimum Cutting Parameters Affecting the Surface Form Properties in the Ductile Stainless Steels with Gray Relational Analysis Method
Journal Title: Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji - Year 2018, Vol 6, Issue 3
Abstract
In this study, the effects of cutting parameters with different coatings (TiAlN and TiN) on drilling performance were investigated. Drilling operations were carried out on duplex stainless steels by drilling holes 20 mm deep with 5 mm diameter drills using cooling fluid. Three different cutting speeds (15, 20 and 25 m / min) and 3 different cutting feed values (0.05, 0.075 and 0.1 mm / rev) were used in the experiments. The effects of different drills and cutting parameters on surface form properties have been measured. The experiments were carried out according to the L18 orthogonal test design. The obtained deviation from cylindricality and the deviation values were optimized by means of gray relational analysis method and the appropriate cutoff parameter was determined as A2B1C1.
Authors and Affiliations
Ahmet MAVİ
Keywords
Related Articles
- EP ID EP491134
- DOI 10.29109/gujsc. 395667
- Views 72
- Downloads 0
Bandwidth Efficient Overlapped FSK Coded Secure Command Transmission for Medical Implant Communication Systems
Nowadays, wireless communication systems are exploited in most health care systems. Implantable Medical Systems (IMS) also have wireless communication capability. However, it is very important that secure wireless commun...
The Investigation of Thermal Conductivity Coefficients of H3BO3/PP Composites
In this study, it is aimed to provide additional contributions to insulating and energy savings by lowering the thermal conductivity values of the polypropylene used in areas where especially the insulating properties ar...
Review of the Solid-State Transformers and an Application of Full Bridge DC/DC Converter
With the increased power to weight ratio, corresponding to the developments in material science, the demand for high frequency transformers (HFT) in air, land, marine and aerospace technologies where the weight is partic...
Traditional City Pattern and Houses of Çanakkale-Bozcaada
Looking closely to Bozcaada architectural characteristics, it is possible to see Turkish and Rum influence. For instance, the houses in Alaybey neighborhood have the architectural characteristics of the former, while the...
Changes in Mechanical, Rheological and Morphological Properties of Glass-Fiber Reinforced Poly(oxymethylene) Composite after Ageing in Laboratory Environment and Water
In this study, the changes in mechanical, rheological and morphological properties of glass-fiber reinforced poly(oxymethylene) composite after ageing were investigated. Samples were prepared with plastic injection moldi...