Devices for measuring the capacitance of micromechanical sensors of mobile robots navigation systems and its deviation from the nominal value
Journal Title: Вісник Житомирського державного технологічного університету. Серія: Технічні науки - Year 2016, Vol 78, Issue 3
Abstract
The article describes methods of constructing devices for measuring the capacitance of micromechanical sensors (accelerometers and gyros) mobile robots navigation systems and its deviation from the nominal value. A modified diagram of a sigma-delta modulator is offered. It realizes a direct connection capacitive sensor connection to the sigma-delta converter, as a result increased resolution, accuracy and linearity of the conversion. This interface is insensitive to the value of capacitance between the sensor leads and common wire or leakage current to a common wire. Variants of expansion as the nominal of the test capacity and the range of conversion of the relative deviation of the nominal capacity using two integrators are offered. The versions of circuit implementation devices for measuring the capacitance deviation of a micromechanical sensor from the nominal value are designed on the basis of the completed integrated circuit AD7745 / AD7746 and AD7747 of Analog Devices, CAV414 / 424 firm Analog Microelectronics and precision analog microcontroller ADuCM360 / CM361 company ARM Limited.
Authors and Affiliations
A. V. Rudyk
Keywords
Related Articles
- EP ID EP254558
- DOI -
- Views 99
- Downloads 0
Scientific and practical problems of reflection of land resources in accounting
The implementation of the land market in Ukraine actualizes the problems of accounting of land resources from viewpoints of generation of accurate and trustworthy information about quantitative, qualitative, and cost ind...
Technological complex of field synthesis of products from nonmetallic composites
The technological complexes of layer-by-layer synthesis of products, applied non-metallic composites and technologies for their preparation, allowing to create various construction designs of wide application in additive...
Operative testing of Q - factor of impulsive transformers
In the process of service of computer and telecommunication equipment disrepairs can arise. Modern computer and telecommunication equipment is characterized by quite complicated circuit technology that is why a process o...
Peculiar features of modeling of thermal processes of the cutting area in the SOLIDWORKS SIMULATION system
Management of thermo-physical process of cutting zone by changing certain parameters of the cutting regime, tool geometry or coolant using allows to achieve a higher level of handling performance. The forecasting of ther...
Research of the stress condition of cast billets blade chisel
Models of a drill bit and a mold were developed. Melted steel pouring process was studied. Residual stresses distributions for different sections of a blade bit were studied. The highest residual stresses were observed i...