Effect of Caries Removal Methods on the Shear Bond Strength of Resin and Glass IonomerAdhesives to Primary Dentin
Journal Title: Journal of Dental Biomaterials - Year 2015, Vol 2, Issue 4
Abstract
Statement of Problem: There is no enough published data about the shear bond strength of resin modified glass ionomer adhesives on caries-affected primary tooth dentin excavated using minimally invasive systems. Objectives: To evaluate the shear bond strength of 2 different adhesives (one resin modified glass ionomer and one resin) using two caries removal tech- niques on healthy and caries-affected primary dentin. Materials and Methods: Two caries removal methods including mechanical (handpiece) and chemomechanical (Carisolv) techniques and two types of ad- hesives including one resin adhesive (Clearfil SE Bond; CSEB, Kuraray) and one resin-modified glass ionomer adhesive (Riva Bond LC; RBLC, SDI) were used in this study. Ten extracted healthy primary teeth were used for the control group. The teeth were sectioned bucco-lingually and mesio-distally in order to obtain four specimens from each tooth. Thirty suitable specimens were selected as the “control” and randomly divided into two groups of “sound dentin” based on the type of the adhesive used. Sixty extracted caries affected teeth were used for the carious group; sectioned as mentioned above and sixty suitable specimens were selected as the “treatment”. Then the specimens were arbitrarily divided into four groups based on caries removal techniques and the type of ad- hesive used (n = 15). After bonding with either CSEB or RBLC, the specimens were restored with a resin composite by means of PVC tubes and subjected to the shear bond strength test. The data was analyzed using ANOVA and Tukey’s test. Results: The specimens in Carisolv group bonded with CSEB (11.68 ± 3.1) showed a statistically significant higher mean bond strength followed by those in handpiece group bonded with CSEB (9.4 ± 2.7), which exhibited higher mean values than those groups with RBLC (p < 0.05). Shear bond strength values for Clearfil SE Bond was not significantly higher than Riva Bond LC when used in sound dentin. Conclusions: The lowest shear bond strengths for both adhesives were observed on caries-free dentin.
Authors and Affiliations
N Mohammadi, M Ferooz, T Eskandarian, R Bagheri
Keywords
Related Articles
- EP ID EP248928
- DOI -
- Views 55
- Downloads 0
Effect of Different Bleaching Techniques on Microleakage under orthodontic Brackets: In Vitro Study
Statement of problem: Numerous studies report significant changes in tooth color that occur during orthodontic treatment. The adverse effects of bleaching procedures during orthodontic treatments have not been studied co...
Comparison of Bone Biomechanical Behavior around Three Different Mini-Implant Systems Employing Finite Element Method
Statement of Problem: Placement of mini-dental implants when single-tooth restorations are needed and the space is not sufficient to insert a standard diameter implant is indicated. There are many different mini-implant...
Analysis of Ground Water Fluoride Content and its Association with Prevalence of Fluorosis in Zarand/Kerman: (Using GIS)
Statement of Problem: The concentration of fluoride in water is usually higher in areas around the coal mines. Zarand region in the south-east of Iran is known for its coal mines. Some studies have shown the high prevale...
Comparison of Viscosity among Four Orthodontic Adhesive Primers in Two Different Temperatures
Statement of Problem: The viscosity of orthodontics adhesive primers is cru- cial for stability and correct brackets ‘position during bond up. An excessive adhesive flow during brackets seating could change the brackets’...
Antimicrobial Effect of Copper Oxide Nanoparticles on Some Oral Bacteria and Candida Species
ABSTRACT Statement of Problem: Acid producing bacteria including Streptococcus mutans and lactobacilli cause tooth demineralization and lead to tooth decay. Also, oral colonization of the species of Candida has been repo...