EFFECT OF CUTTING SPEED ON GENERATION OF HEAT AT WORK-TOOL INTERFACE OF COPPER BASED SILVER AND BRASS ALLOYS
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 3
Abstract
Copper and its alloys are extensively used in various electrical and other industrial applications, due to its high thermal and electrical conductivity. The machinability of copper depends on its alloying elements and its composition. The addition of alloying elements reduces machinability and hence the amounts of heat generated also variable which is dependent on the composition of the alloying element and the machining parameters. The current research is an attempt to study the amount of heat generated at the work tool interface for varying cutting speeds and varying compositions of brass and silver in copper. The research reveals that the number of heat generated decreases as the amount of silver content increases in the alloy indicating higher thermal conductivity.
Authors and Affiliations
Keywords
Related Articles
- EP ID EP377237
- DOI -
- Views 79
- Downloads 0
Operational Study of Circulating Fluidized Bed Steam Generator
The paper aims at studying the operation of a lignite fired Circulating Fluidized bed Combustion steam generatorof 250 MW capacity located at NeyveliinTamilnadu in South India. Circulating fluidized bed combustion(CFBC)...
Fabrication and Properties Evaluation of CNT Polymer Composites
In polymer and metal matrix composites that form a strong bond between the fiber and the matrix, the matrix transmits loads from the matrix to the fibers through shear loading at the interface. In component designing, th...
Mathematical Modelling to Predict the Residual Stresses Induced in Milling Process
Residual stresses prediction has been challenge over the years. Many models have been developed in order to predict the residual stresses. Research has been taking place in this field since many decades. Numerical, exper...
Mechanical Behaviour of Glass Fiber Reinforced Epoxy Composite Material
The main objective of this work is to study the three samples of glass fibre reinforced with three different ratio of epoxy resin. In this study the different weight percentage of given material properties are identified...
Investigation of Machining Parameters By Using PVD Coated TiIAlLN
AISI D2 steel is the leading candidate material used in dies for the production of automobile products and electronic parts. The machinability of the material involves tool life, cutting forces, chip formation with less...