Fundamentals of Creation of New Devices for Speed Change Management
Journal Title: Український журнал із машинобудування і матеріалознавства - Year 2015, Vol 1, Issue 2
Abstract
The article deals with problem of speed change management in engineering, i.e., hoisting, building, road and land reclamation machines, cars and tractors, machine tools and other equipment. The review of the methods and devices for stepped, steppless and combined speed change process management have been performed. Their major disadvantages have been identified. Among others, main disadvantages of stepped speed management devices are the complexity of design, their large material consumption, the emergence of dynamic loads during the transition from one speed to another, even in case of synchromesh using. Continuously variable speed devices have intense components wear due to the use of friction connections like brakes or lock-up clutches. The authors lead to the conclusion about the need for new devices of speed change management to remove, or at least decrease, identified deficiencies. New devices suggested for speed changes management via epicyclic gear trains with a closed circuit hydrosystem. Those new constructions are supposed to remove abovementioned shortcomings and can be the basis and foundation for new devices creation and their further research.
Authors and Affiliations
Volodymyr Malashchenko, Oleh Strilets
Keywords
Related Articles
- EP ID EP200059
- DOI -
- Views 108
- Downloads 0
Justification of Efficiency of Elliptical Gear Train in Device for Speed Changes Management
The article analyses the functioning of epicyclical gear train with closed circuit hydrosystem, where the driving element is the sun gear and driven one is the carrier or vice versa. Control element is the ring gear, whi...
Dynamics of two-mass mobile vibratory robot with electromagnetic drive and vibro-impact operation mode
The purpose of research. Substantiation of inertial, stiffness and excitation parameters of mechanical oscillatory system of mobile vibratory robot in order to maximize its motion speed. Methodology. The technique of the...
Regulation of the phase-structural composition and metastability of austenite by alloying elements and parameters of tempering for increase wear-resistance of Fe-Cr-Mn deposited steel
It is shown that under the influence of alloying (Cr, Mn, C, Si, Ti, N, V) during electric arc hardfacing with a flux cored wire, as well as technological tempering parameters at temperatures of 300...700°C, the phase-st...
Dynamic Properties Predictions for Laminated Plates by High Order Theories
The main aim of this study is to predict the elastic and damping properties of composite laminated plates. Some approximate methods for the stress state predictions for laminated plates are presented. For simple uniform...
Optimization of Conditions of Electroslag Welding of Bandings of Rotary Units
The design of banding shells of rotary units is analyzed. It is shown that combined welding and cast manufacturing of bandings is used in the case of large structural sizes. The basic materials (30, 35, 25 HSL and 30 HML...