Improving contact durability of polycrystalline systems by controlling the parameters of large-angle grain boundaries
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2019, Vol 5, Issue 12
Abstract
Polycrystalline metal systems in the samples made of steel 40X with different morphology and parameters of the distribution of large-angle grains boundaries for energy have been examined. The effect of the structural-energy state of grains boundaries on the operational reliability of improved steel 40X has been established. Based on the hierarchical modeling of polycrystals structure, new approaches have been proposed and algorithms have been developed for defining relationships between the structure that is formed in the technological processing of materials and stages in the life cycle of parts. It has been revealed that it is advisable to use, as a digital prototype of the structure of polycrystalline alloys that describes their performance under conditions of contact loads, the matrix representation of a system model that would incorporate the quantitative characteristics of grains. By using the devised procedures, the ways to execute technological control over the energy state of grain boundaries in the structural components have been defined in order to improve durability of parts exposed under contact loads. An estimation-experimental method has been developed to assess the effect of quantitative characteristics of the structure on the parameters of strength of the grains boundaries and their ability to form intragrain damage under external loads. The energy level of grains boundaries and triple joints between the groups of small and large grains is higher than that between grains of the same size. The boundary surfaces with a high level of energy are places where damage occurs at technological processing and under external loads on structural materials. This points to the crucial role of large-angle boundaries placed between triple joints with a high energy gradient in the process of forming microstructurally short cracks and intragrain destruction of polycrystalline systems. The use of hierarchical modeling methods and computational materials science makes it possible to improve the operational reliability of articles by choosing the optimal parameters for internal boundary surfaces. The lower cost of the parts' life cycle is achieved by thermal treatment regimes, which alter the quantitative characteristics of the steel structure
Authors and Affiliations
Viacheslav Kopylov, Oleg Kuzin, Niсkolay Kuzin
Keywords
Related Articles
- EP ID EP668852
- DOI 10.15587/1729-4061.2019.181441
- Views 79
- Downloads 0
Development of the method for estimating serviceability of equipment for the transportation of compressed natural gas
<p>To ensure safe transportation of compressed natural gas, we proposed, based on the results of studies conducted, the algorithm for a method for the evaluation of combined type tanks. The method implies determining par...
Rationale for creating detonation CO2 laser for radioactive surface decontamination
<p>The laser decontamination method is based on the evaporation of oxide films under the influence of radiation. With the evaporation mechanism, laser radiation should heat the upper layer of the film to the boiling poin...
Development of the electrochemical synthesis method of ultrafine cobalt powder for a superalloy production
<p>The electrochemical synthesis method for the preparation of ultrafine cobalt powder from the sulfate-ammonium electrolyte for the preparation of superalloys<span style="text-decoration: line-through;">,</span> has bee...
An impact of the ladle lining on the refining of reinforced steel when blowing with powders
<p>When refining steel by blowing powders, the ladle lining material plays a serious role. The dependency graphs of the degree of desulfurization on the consumption of silicocalcium powder during blowing in ladles lined...
Construction and investigation of a method for measuring the non-stationary pressure using a wavelet transform
<p>Automated control systems badly need measurements of fast-changing non-stationary physical quantities in real time, or close to that. In this area, there is a separate group of tasks on measuring the non-stationary pr...