Influence of Cutting Regime Parameters on Edge Endurance of Lathe Tool
Journal Title: Analele Universitatii "Eftimie Murgu" Resita. Fascicula de Inginerie - Year 2014, Vol 21, Issue 1
Abstract
In mechanical industry, to increase productivity is very important to correctly establish the factors that influence the process dynamic. One of these factors is the features cutting regime. In practice, the technological process optimization depending by the value of the characteristics parameters. The paper purpose is to reveal the influence of operating speed and penetration speed over edge endurance of a lathe tool.
Authors and Affiliations
Ana-Maria Budai
Keywords
Related Articles
- EP ID EP459125
- DOI -
- Views 81
- Downloads 0
Forecasts of the Maintenance Activity
Enhancing the machines’ technical and technological performance through constructive improvements that allow for the automation of orders, contributes to the increasing of the production capacity of the system and for ma...
Researches Regarding the Factory Test of Electric High-duty and High voltage Equipment
This paper shows a review of the present methods of testing the high-duty and high voltage electric machines and transformers, to which the authors brought their own contributions concerning their elaboration and exploit...
Study on the Evolution of Weights on the Market of Competitive Products using Markov Chains
In this paper aims the application through the Markov Process mode, within the software product WinQSB, Markov chain in the establishment of the development on the market of five brands of athletic shoes.
Gas Boiler Powered by the Fuel Cell System
The paper presents a new solution for supply of boilers with electrical energy in the order to achieve autonomy from electrical grid. The paper presents the experimental system implemented in the university lab, the comp...
Statistical Analysis of the Results of Surface Treatment with Optical Pulses Applied to Parts of Metallic Powders
Within a wide range of theoretical and experimental research, the possibility of realizing a new method of superficial treatment of materials made of metallic powders and the validation of the results obtained after the...