Influence of milling and sanding on beech wood surface properties. Part II. Wetting and thermo-dynamical characteristics of wood surface
Journal Title: Annals of WULS, Forestry and Wood Technology; Zeszyty naukowe SGGW - Year 2016, Vol 95, Issue 1
Abstract
The aim of the second part has been to investigate the influence of beech wood mechanical treatment on wood surface wetting with standard apolar and polar-apolar liquids. Experimentally measured contact angles formed by drops situated on different treated beech wood surfaces were used for calculation of wood surface free energy together with its disperse and polar components. The experimental results show that the diverse mechanical treatments of beech wood surface differed not only in their impact on the surface morphology but also on the wetting process and surface free energy of beech wood. The milled surfaces displayed worse wetting compared to the sanded ones. This was reflected in higher contact angle values. The determined surface free energy values of beech wood were higher for sanded surfaces. There were also observed differences in the ratio between the disperse and polar components. The results obtained document that each of the surface treatments tested meets requirements for ensuring high surface treatment quality. More suitable, however, from this viewpoint was the wood surface treated by sanding. Keywords:
Authors and Affiliations
JOZEF KÚDELA, LEOŠ MRENICA, ĽUBOMÍR JAVOREK
Keywords
Related Articles
- EP ID EP361731
- DOI -
- Views 59
- Downloads 0
Изменения прочностных свойств гравировой кожи
Целью работы создание подходящей степени гравировки кожи различной плотности на базе глубины выгорания и определения влияния различных степеней гравировки на крепкость кожи. Для эксперимента были отобраны образцы для исп...
Proportion of juvenile wood and mature wood in stems of Norway spruce (Picea abies L. Karst.) origin from forests grown in different site conditions
Proportion of juvenile wood and mature wood in stems of Norway spruce (Picea abies L. Karst.) origin from forests grown in different site conditions. This study presents research of 8-metres logs obtain from Norway spruc...
Прочность соединений древесины приклеиваных в паперечной и продольной плоскости
Прочность соединений древесины приклеиваных в поперечной и продольной плоскости. Целью статьи является нахождение прочностьи соединений древесины приклееваных на тупо состоящий из одной поперечной стороны и з другой...
Finger- joints in lamellas of beech wood (Fagus sylvatica L.)
Finger- joints in lamellas of beech wood (Fagus sylvatica L.) Due to the lack of quality spruce construction timber, a new alternatives are being searched and considered, beech (Fagus sylvatica L.) timber mostly. It´s us...
The influence of the fast road on the content of some microelements in wood and bark of White mulberry (Morus alba L.)
The influence of the Fast Road on the content of some microelements in wood and bark of White mulberry (Morus alba L.) Samples for studies were collected from white mulberry tree grown in the close neighborhood of the fa...