Maximum power point tracking in PV systems based on adaptive control and sliding mode control
Journal Title: Revista Facultad de Ingeniería-Universidad de Antioquia - Year 2015, Vol 1, Issue 75
Abstract
Photovoltaic (PV) systems are commonly controlled using PI or PID structures, which cannot ensure global stability and a constant settling time. Therefore, the optimization algorithms, e.g. Perturb and Observe (P&O), are designed using the highest settling time in the operating range, which produces a slow tracking of the maximum power point (MPP) for the largest part of the operation range, introducing dynamic power losses to the system. This paper proposes to combine an adaptive controller and a sliding mode current controller (SMCC) to guarantee global stability and a constant settling time for any operation condition, which enable to increase the generated power in comparison with PI and PID controllers. The SMCC enables to mitigate the system perturbations and guarantee global stability, while the adaptive controller defines the reference of the SMCC to ensure a constant settling time. The design of the new control structure is supported by mathematical analyses and simulations made in Matlab®, where the robustness of the system is validated.
Authors and Affiliations
Paula Andrea Ortiz-Valencia, Luz A. Trejos-Grisales, Carlos A. Ramos-Paja
Keywords
Related Articles
- EP ID EP626933
- DOI 10.17533/udea.redin.n75a08
- Views 106
- Downloads 0
Influence of precipitation scavenging on the PM2.5/PM10 ratio at the Kennedy locality of Bogotá, Colombia
Objective: To establish whether the scavenging effect reduces the PM2.5/PM10 ratio in rainy periods in comparison with dry periods, at the Kennedy locality of Bogotá, Colombia. Materials and methods: Relationships among...
Simulating gas-liquid mass transfer in a spin filter bioreactor
Computational fluid dynamics (CFD) and population balance model (PBM) model have been used to simulate hydrodynamics and mass transfer in a 0.014 m3 Spin Filter Bioreactor. The operating conditions chosen were defined by...
Chitosan/hydroxyapatite scaffolds for tissue engineering manufacturing method effect comparison
The regeneration of bone is one of the main challenges of modern medicine because many diseases including trauma and tumor can cause bone defects. Tissue engineering (TE) is a promising approach to cure these bone diseas...
A two-stage decision support model for a retail distribution center location
This paper proposes a model to support the decision-making process of selecting the location of a distribution center for the retail sector. The model was structured in two stages to consider objective and subjective cri...
Productivity and energy efficiency of three tillage systems for maize (Zea mayz L.) production
The amount of inputs and dry matter yields of grain, stover and weeds were quantified in six sites located in the districts of Zaachila and Etla, in the Central Valleys of Oaxaca Region, México. The tillage systems evalu...