Isotropic Radiation Using Crossed Dipoles
Journal Title: INTERNATIONAL JOURNAL OF ENGINEERING TRENDS AND TECHNOLOGY - Year 2013, Vol 4, Issue 4
Abstract
This letter presents a compact isotropic-radiated planar antenna for 2.5-GHz wireless local area network (WLAN) applications. The antenna is designed using two crossed curved dipoles. By adjusting the lengths of the two crossed curved dipoles, an isotropic radiation pattern is achieved in the whole band of 2.5–2.58 GHz. The proposed antenna is simulated. The simulation results show that the difference between the maximum and the minimum of gains is smaller than 5 dB in the full space
Authors and Affiliations
Praturi Vivekanand#1 , Pillem Ramesh
Keywords
Related Articles
- EP ID EP130619
- DOI -
- Views 113
- Downloads 0
An Energy Efficiency Routing Protocol for Improving Lifetime of Wide Area Wireless Sensor Networks: A Review
The key challenge in wireless sensor network protocol designs is to provide energy efficient communication, as most of the nodes in sensor networks have limited battery power and it is not feasible to recharge or replace...
An Implementation on Detection of Trusted service provider in Mobile Ad-hoc Networks
The mobile ad-hoc network consists of energy constraint devices called nodes communicating through radio signals forming a temporary network i.e. nodes are continuously switching from one network to another. To minimize...
Crt Based Rsa Algorithm For Improving Reliability And Energy Efficiency With Kalman Filter In Wireless Sensor Networks
Broadcast authentication is a critical security service in wireless sensor networks (WSNs). However, due to resource constrained of sensor nodes, providing an authentication mechanism for broadcast message is dif...
An Efficient Carry Select Adder with Less Delay and Reduced Area Application
Design of area, high speed and power-efficient data path logic systems forms the largest areas of research in VLSI system design. The addition speed is limited by the time necessary to transmit a carry through the...
Control of Moisture Content in Bagasse by Using Bagasse Dryer
Sugar mill wet bagasse is used as a fuel in sugar industry worldwide. The moisture content on the bagasse is effort on the calorific value (CV) of bagasse and boiler efficiencies. Industries and research institutes...