Physical properties of Nano based Bio-Oils as cutting fluids
Journal Title: Journal of Advanced Research in Manufacturing, Material Science & Metallurgical Engineering - Year 2018, Vol 5, Issue 3
Abstract
The performance of any cutting fluid depends on its physical properties. A good cutting fluid should have high flash and fire point, so that it can withstand high temperature; resulted due to friction between tool-chip interface & tool -workpiece interface. Viscosity should not be high as cutting fluid will not carry away the heat and chip produced. It should not be low also as, the oil just flows from machining zone without doing its intended function, hence Viscosity should be optimum. Cutting fluid should have high specific heat so that heat absorption will be high and optimum Adhesivenessfor good lubrication. The present paper discusses the physical properties of various bio-oils,SAE 20W40 (petroleum based oil), and compares the results measured with the addition of nano Graphite powder
Authors and Affiliations
Susmitha Medarametla,
Keywords
Related Articles
- EP ID EP535301
- DOI -
- Views 137
- Downloads 0
An Experimental Investigation During Electric Discharge Machining of Tool Steel-D2
Electrical Discharge Machining (EDM) is the one of the earliest non-traditional machining processes. Today, many parts used in the aerospace and automotive industries and in the final processes of surgical can be finishe...
Experimental Assessment of a Laboratory Rotary Sample Splitter
A binary mixture of iron chips and sand was used to experimentally test the performance of a constructed laboratory sample splitter. Four tests were conducted and six subsamples were produced in each case. The subsamples...
Microstructure and Characterization of Ni-Cr Alloy-Spray Repaired Steel
In today’s era of manufacturing, wear upon the surface of component is the major problem of all materials. This wear can be reduced to great extent by applying some coating onto the surface of material. The as-sprayed co...
Nanomaterials based Electrodes for Electrochemical Sensor
Carbon nanoparticles and Zinc oxide material is a unique material for marking electrode for electrochemical sensing of heavy metal ions in the water. Carbon has unique properties. We proposed simple method for preparatio...
Knowledge Exchange and Organizational Ambidexterity in Manufacturing Companies in Lagos
This paper presents an empirical relationship between knowledge exchange and organizational ambidexterity of manufacturing companies in Lagos. The study adopted the cross-sectional survey research method and a quantitati...