Preparation and Tribological Properties of Ni Based Wear Resistant Coating by Plasma Cladding

Journal Title: 河南科技大学学报(自然科学版) - Year 2019, Vol 40, Issue 1

Abstract

The Ni based wear-resistant coating was prepared by plasma cladding technology on the surface of 20 steel by using the commercial WF260 alloy powders. The friction and wear behavior of the coating under dry friction condition at room temperature were investigated by the MM-200 tribo-tester. The microstructure and phase composition of the coating were observed by scanning electron microscope (SEM), energy dispersive spectrometer (EDS) and X-ray diffractometer (XRD) . The results indicate that the coating exhibites a lamellar structure and has a good metallurgically bond with the matrix. Some pores exist on the surface of the coating and a large amount of the dendrites are also found in the coating. The coating mainly consists of γ- (Ni, Fe), (Fe, Cr, Ni) mCn, Cr2Ni3, BPO4 and Fe5C2 phases. The wear rate of the 20 steel and the coating are 1.90 mm3/min and 0.26 mm3/min respectively. The wear resistance of the 20 steel is greatly improved by the coating. The main wear mechanisms of the coating are abrasive wear and oxidation wear, and the main strengthening mechanisms are dispersion strengthening and solution strengthening.

Authors and Affiliations

Mingming YAN, Sanming DU, Chao Liu, Yongzhen ZHANG

Keywords

Related Articles

Fault Diagnosis of Rolling Bearing by Improved Hilbert-Huang Transform

An improved Hilbert-Huang transform (HHT) time-frequency analysis method was proposed based on complete ensemble empirical mode decomposition with adaptive noise (CEEMDAN) .A set of intrinsic mode function (IMFs) was gai...

Preparation and Microwave Dielectric Properties of Cold Sintering Ceramics Materials

The NaCl, Li2MoO4, Al N-Na Cl and Zn2SiO4-NaCl materials were sintered by cold sintering method.The dielectric properties of cold sintering materials were investigated at microwave frequency ranges.The results show that...

Effects of Diesel Oxidation Catalyst on Particulates Emission from Diesel Engine

In order to study the effects of diesel oxidation catalyst( DOC) on the characteristics of particulates emission from diesel engine,the particulates of three high-load conditions of the CY4102-CE4 B diesel engine were co...

Comparison of Uncertainty Evaluation Method Based on Bayesian Principle

Aming at the limitation of the uncertainty evaluation only according to measuring sample information,the measurement uncertainty evaluation and updating method based on non-informative prior,conjugate prior and maximum e...

Cross-Layer Transmission Optimization Strategy in Wireless Sensor Networks

To solve the problem that the wireless sensor networks( WSNs) had lower transmission efficiency currently,a WSNs transmission optimization strategy based on cross-layer access was proposed. By cross-layer access mechanis...

Download PDF file
  • EP ID EP427023
  • DOI 10.15926/j.cnki.issn1672-6871.2019.01.001
  • Views 85
  • Downloads 0

How To Cite

Mingming YAN, Sanming DU, Chao Liu, Yongzhen ZHANG (2019). Preparation and Tribological Properties of Ni Based Wear Resistant Coating by Plasma Cladding. 河南科技大学学报(自然科学版), 40(1), 1-5. https://europub.co.uk./articles/-A-427023