Rancang Bangun Unipolar PWM Dilengkapi dengan Pengaturan Frekuensi Menggunakan Operational Amplifier
Journal Title: Jurnal Ecotipe (Electronic, Control, Telecommunication, Information, and Power Engineering) - Year 2019, Vol 6, Issue 1
Abstract
Pulse Width Modulation (PWM) is applied to power electronic circuits for the control of converter circuits. In order to obtain good performance, the frequency of the PWM pulse must be adjusted to the type and parameter of the converter. In this study, the PWM pulses generated are unipolar PWM. Pulses are obtained by using three main circuits, namely triangular wave generator, control voltage and comparison circuit. The main component used is Operational Amplifier (Op-Amp). The resulting circuit can generate unipolar PWM pulses with frequency range 30 Hz to 5 kHz.
Authors and Affiliations
Asmar Asmar
Keywords
Related Articles
- EP ID EP549355
- DOI 10.33019/ecotipe.v6i1.942
- Views 66
- Downloads 0
Perancangan Jaringan Indoor 4G LTE 1800 MHz Gedung Elektronika Politeknik Negeri Balikpapan Menggunakan Radiowave Propagation Simulator 5.4
Indoor area is an area that lacks a signal so that the signal attenuation continues to be problems that often occur. To overcome these problems need the support of a communication system that can include a signal in the...
Sistem Informasi Objek Wisata Jelitik Kabupaten Bangka Berbasis Webserver
Bangka has a beautiful tourist destination and attract tourists to visit, especially coastal tourism. One of them is a tourist destination in the village of Jelitik with beautiful and interesting beach tourism potential...
Pengaruh Ketidakseimbangan Beban Terhadap Stabilitas Steady State
The stability of the electric power system is related to the balance of power in the system. When a power change occurs, the rotor will swing affecting the power angle, rotation speed, frequency and stability of the syst...
Disain Kontroler PI dengan Decoupling pada Sistem Kendali Level Coupled Tank
The problems on the Coupled Tank control level is the existence of disturbance in the flow that supplies tank would make unstability response, so it could happen the cross interaction between input and output. PI control...
Rancang Bangun Unipolar PWM untuk Pengendalian Rangkaian H-Bridge Menggunakan Operational Amplifier
Unipolar PWM control technique carried out by comparing triangular wave with two control voltages. The resulting pulses are used to control H-Bridge circuit. The technique can be done by using the functions of the operat...