Research of the reliable zone of suitable fits in the case of automated design
Journal Title: Вісник Житомирського державного технологічного університету. Серія: Технічні науки - Year 2017, Vol 80, Issue 2
Abstract
The work is searching for the forms of reliable zone for selection rational fit in a two-dimensional coordinate system and suggests an algorithm for their analytical description using the mathematical apparatus of the theory V.A. Salo, A.P. Gorbunov, V.M. Nechyporenko. Research of the reliable zone of suitable fits in the case of automated design. R – functions on the example of interference fit in the case of automated design.
Authors and Affiliations
V. A. Salo, A. P. Gorbunov, V. M. Nechyporenko
Keywords
Related Articles
- EP ID EP255755
- DOI -
- Views 107
- Downloads 0
Improving the effectiveness of detailed processing by dynamic control of processing with high sports range
In this article the possibility of increasing the efficiency of the processing of parts with a diameter of up to 20 mm is analyzed, namely: vibration resistance of the cutting process at pinching due to cutting speed con...
Technique and results of laboratory research of greenhouse soils' moisture computerized meter
The decision of scientific and practical tasks on development and research of computerized laboratory test methods of non-destructive measuring control technical means of greenhouse soils moisture is a prerequisite for s...
Experimental research of the frequency dependence of microwave radiation coefficients of reflection and transmission in the nanometer conductive inclusions
The current state of research of electrodynamic properties of one-dimensional photonic crystal waveguide is analyzed. The crystals interaction with electromagnetic radiation microwave range by the need to determine the p...
Automobile systems monitoring on the basis of diagnostic signal analysis
The specificity of various mechatronic systems functioning in a modern car gives opportuinity to analyze diagnostic signals (oscillograms) of different nature, which are read from the diagnostics characteristic points or...
About the influence of lubricating-cooling agents on the cutting process
Set forth problem of necessity of increase of workability of metal. On the basis of generalization of researches at the area of physics – chemical mechanics of materials the offered hypothesis on the permanent activating...