RESEARCH ON HYSTERESIS OF TRIGGERING PROBES APPLIED IN COORDINATE MEASURING MACHINES
Journal Title: Metrology and Measurement Systems - Year 2005, Vol 12, Issue 4
Abstract
The article presents selected results of investigation of triggering probe hysteresis in coordinate measuring machines. The research covered the hysteresis of pretravel of one-stage triggering probes equipped with a switching transducer (represented by TP6 probe), and two-stage probes equipped with a piezoelectric transducer (e.g. TP200 probe). The effects of stylus length, measurement pressure and approach speed to the measured surface have been included in the performed tests. The variance analysis methods have been used to evaluate the effects. The results, obtained in various conditions and using different probes, have been compared. As a result, optimum values of tested parameters have been estimated, as far as they concern the operation accuracy of the probe.
Authors and Affiliations
ADAM WOŹNIAK, MAREK DOBOSZ
Keywords
Related Articles
- EP ID EP96833
- DOI -
- Views 65
- Downloads 0
PERFORMANCE OF A NEW SET OF IN, SN AND ZN TEMPERATURE FIXED-POINTS
A comparison of a new set of "In, Sn and Zn" temperature fixed-points on the International Temperature Scale of 1990 (ITS-90) was carried out at the National Institute of Standards (NIS - Egypt). The new set was manufact...
PERIODICALLY VARIABLE TWO-TERMINAL IMPEDANCE DESCRIPTION AND MEASURING METHODS
The subject of this paper is the problem how to describe and measure impedance of a linear periodically time-varying (LPTV) two-terminal. If the two-terminal parameters change synchronously to the supply the two-terminal...
THE ANTIALIASING FILTER PARAMETERS PROPOSITION FOR LABORATORY AND DOMESTIC EQUIPMENT APPLICATION OF POWER QUALITY MEASUREMENTS SYSTEMS
Digital signal processing exists in systems which perform the processing of power waveforms. All measuring devices that use digital signal processing and computing of its discrete spectrum should be equipped with an anti...
ON IMPROVEMENT OF SAMPLING TECHNIQUE DESIGNED FOR PRECISE ROOT MEAN SQUARE MEASUREMENTS<br />
A method for precise root mean square (RMS) measurement of periodic signals based on signal reconstruction is analysed. The RMS value of a signal under test is determined in three steps. In the first step, the Fourier co...
DETERMINING THE UNCERTAINTY OF FITTING DISCRETE MEASUREMENT DATA TO A NOMINAL SURFACE
Coordinate measurements are a source of digital data in the form of coordinates of measurement points with a discrete distribution on the measured surface. Geometric deviations of freeform surfaces are determined at each...