RESEARCH ON THE APPLICATION OF DIESEL-RK IN THE CALCULATION AND EVALUATION OF TECHNICAL AND ECONOMIC CRITERIA OF MARINE DIESEL ENGINES USING THE UNIFIED ULSD AND BIODIESEL BLENDED FUEL
Journal Title: Journal of Mechanical Engineering Research & Developments (JMERD) - Year 2019, Vol 42, Issue 2
Abstract
In the current trend of technology and computer science development, the application of computer software to solve technical problems in dynamics and combustion of engines becomes easier. However, commercial software packages have very high prices and are difficult to access to small researchers and researchers in developing countries like Vietnam. In that software, Diesel-RK is considered a very good open source software for young researchers, because it is free and capable of simulating combustion and thermodynamics of diesel engines very well. This paper presents the results of the Diesel-RK application to simulate combustion and fuel injection for a marine diesel engine using a homogeneous fuel mixture from ultra-low sulfur fuels (ULSD) and base-palm oil biodiesel fuel (BO). The simulation results are used to evaluate the criteria of power, pressure, and temperature in the engine combustion chamber, and provide very useful data about soot emissions and NOx when using five types of fuel are ULSD, ULSD-B5, ULSD-B10, ULSD-20, ULSD-B50 and ULSD-B100.
Authors and Affiliations
Van Viet Pham
Keywords
Related Articles
- EP ID EP503673
- DOI 10.26480/jmerd.02.2019.87.97
- Views 63
- Downloads 0
EFFECTIVE TECHNOLOGIES OF DISSOLUTION OF ORGANIC DEPOSITS IN THE BOTTOMHOLE ZONE OF OIL WELLS REGISTRATION FORM
Article deals with problems of oil production on Kazakhstan`s fields. The necessity of search for more effective ways of restoring the initial permeability of bottomhole zone of the formation was established. The assessm...
DEVELOPMENT ORIENTATION FOR HIGHER EDUCATION TRAINING PROGRAMME OF MECHANICAL ENGINEERING IN INDUSTRIAL REVOLUTION 4.0: A PERSPECTIVE IN VIETNAM
.
DESIGN AND DEVELOPMENT OF A LOW-COST 3D METAL PRINTER
3D printing or additive manufacturing (AM) is a technology that enables the fabrication of 3D data by depositing a thin layer of material layer-by-layer until a final product is produced. Recently, the application of met...
INFLUENCE OF SIZE AND WEIGHT FRACTION OF CARBON NANOTUBE ON COEFFICIENT OF THERMAL EXPANSION OF Al-CNT METAL MATRIX
Metal matrix composites are grabbing more attention by researchers due to their outstanding properties which meets the requirements of a specific application. The work presented in the current paper investigates the infl...
A NUMERICAL STUDY OF THE TURBULENCE MODEL INFLUENCE ON A SAVONIUS WIND TURBINE PERFORMANCE BY MEANS OF MOVING MESH
This numerical research has investigated the influence of the turbulence model on a Savonius wind turbine performance. The numerical simulation has been applied by using two-dimensional analysis of Computational Fluid Dy...