Residual moisture of the material during roller squeezing
Journal Title: Modern Innovations, Systems and Technologies - Year 2023, Vol 3, Issue 1
Abstract
The study is devoted to the analytical description of the residual moisture content of the material during roller pressing. It was found that the amount of fluid extracted at the beginning of the compression zone grows faster, then, the growth rate decreases, and at the end of the compression zone, the amount of extracted fluid stabilizes. It was established that the patterns of change in the extracted fluid in the restoration zone depend on the angle that determines the position of the point where the fluid changes direction.
Authors and Affiliations
Sh. R. Khurramov, A. A. Saliyev
Keywords
Related Articles
- EP ID EP716512
- DOI 10.47813/2782-2818-2023-3-1-0112-0123
- Views 56
- Downloads 0
Implementation of monitoring the efficiency of enterprises using a special subsystem of the automated control system
The article discusses the implementation of monitoring the efficiency of enterprises using a special subsystem of the automated control system. It is shown that the analysis within the framework of the performance monito...
The results of experimental research of the mechanism of sewing machine with the shock absorbing rack for material movement
The article presents the results of an experimental study of the mechanism of the sewing machine for pushing through the material with the recommended shock-absorbing bar. The purpose of the experiment was...
Residual moisture of the material during roller squeezing
The study is devoted to the analytical description of the residual moisture content of the material during roller pressing. It was found that the amount of fluid extracted at the beginning of the compression zone grows f...
Overview of the International Conference “Advanced Technologies in Aerospace, Mechanical and Automation Engineering – MIST: Aerospace - III - 2020”
The article provides an overview of the main directions of the scientific program of the III International Conference MIST: Aerospace-III-2020: Advanced technologies in the aerospace industry, mechanical engineering and...
Cutting tool stability and cutting speed
The article notes the importance of mechanical processing of parts produced for agricultural and engineering enterprises. It analyzes the use of modern cutting tools to give machine parts precise dimensions, a clean surf...