slugExperimental Investigation of Shell and Tube Heat Exchanger Using Bell Delaware Method
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2014, Vol 2, Issue 1
Abstract
A heat exchanger is a device that is used to transfer thermal energy between two or more fluids, between a solid surface and a fluid, or between solid particulates and a fluid, at different temperatures and in thermal contact. Shell and tube heat exchangers in their various construction modifications are the most widespread and commonly used basic heat exchanger configuration in the process industries. In the present study, a water to water STHE wherein, hot water flows inside the tubes and cold water inside the shell is used to study and analyze the heat transfer coefficient and pressure drops for different mass flow rates and inlet and outlet temperatures, using Bell Delaware method. This method takes in to account heat transfer by bypass and leakage streams, hence minimizing losses and providing more realistic estimates of heat transfer and pressure drops.
Authors and Affiliations
K Anand, V K Pravin, P H Veena
Keywords
Related Articles
- EP ID EP17744
- DOI -
- Views 374
- Downloads 18
Improved Scalability and Security on Data Retrieval for Decentralized DTN’S Using CP-ABE Algorithm
Mobile Nodes in some challenging network scenarios suffer from intermittent connectivity and frequent divisions, for example in battleground if the network failure occurs then there is a chance to lose the data. Many of...
Optical and Structural Properties of Zinc Oxide Nanowires Fabricated by Hydrothermal Method
Nanocrystalline film of Zinc Oxide (ZnO) nanowires were prepared on glass substrate at a low temperature using a low cost, simple hydrothermal method. We used different concentration of ZnO nanowires precursor solution...
Prediction of Distribution Transformer Premature Failures
This paper deals with two types of Distribution Transformer failure analysis tests which can help in monitoring the Distribution Transformers condition. The three methods are Conventional oil test, Furan derivatives tes...
Analysis of Low Leakage Architecture of SRAM 8x1 Using Leakage Power Reduction Technique in Different Technology
as the size of ic’s is becoming small, day by day the demand of high density vlsi circuits has been increasing .the supply voltage reduction is necessary to reduce the active power. By lowering the supply voltage it is...
A Review of SEM and XRD test of Cement Mortar made with Metakaolin and Flyash Partially Replaced in cement cured in seawater
In this present study the effects of flyash, metakaolin and their combinations has been evaluated for optimal level of replacement as blending component in cement. The results showed that Scanning electron microscope an...