STATICAL EXPERIMENTS OF TIRE AS COMPLEX LONG-FIBRE COMPOSITE FOR OBTAINING MATERIAL PARAMETERS AND DEFORMATION CHARACTERISTICS
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2012, Vol 19, Issue 3
Abstract
The article deals with the statical experiments of tires for obtaining material parameters and deformation characteristics by tensile testing machine and also special statical testing tire machine. The tires consist of polymer matrix – rubber and long-filament reinforcement – cords, hence the tires are fall within as very complex long-fibre composite with specific deformation characteristics. These tire deformation characteristics have given geometry shape of tire and material parameters of component parts of tire-casing. Nowadays the computational modeling is used for tire solutions and experiments are subsidiary only. But the combination of computational modeling with experimental approach is necessary to use for prediction real states of tires. For computational modeling of tires the material parameters of each component part of tire-casing are necessary as material input data for computational models. These material parameters can be obtained by tensile test by statical testing machine. The geometry parameters of multi-layer test specimens of steel-cord belt with conditions of tensile tests are designed. The data from statical deformation characteristics are necessary for comparison of computational outputs with experimental data. The special testing tire machine called statical adhesor is used to obtain deformation characteristics and information about contact patches with pressure distribution in contact patches. The experimental results of chosen radial tire 245/40 R18 for passenger car are presented in this article. In this paper a new formula for calculating of value of radial stiffness is designed too.
Authors and Affiliations
Jan Krmela, Libor Beneš, Vladimíra Krmelová
Keywords
Related Articles
- EP ID EP114357
- DOI -
- Views 170
- Downloads 0
EFFECT OF SHOT PEENING ON FATIGUE PROPERTIES OF STEEL IN DIFFERENT STRUCTURAL STATES
The aim of this paper is to evaluate the effect of shot peening on fatigue properties of dual-phase steels DP 600 in received condition, as well as in condition after different regimes of heat treatment. In the work, the...
Study of the influence of agricultural waste on the porosity of clay brick
This paper deals with the influence of two organic residues on the porosity of clay bricks. The insulation capacity of the brick increases with increasing the porosity. Combustible organic additions are often used to for...
FATIGUE BEHAVIOR OF HOT-ROLLED STEEL INTENDED FOR COLD FORMING
In the work, there are presented measured tension and fatigue properties of eight low-carbon steels moulded in form of 20 kg ingots that were processed by controlled regime of rolling /cooling and then exposed to simulat...
Microstructural changes of AISI 316L due to structural sensitization and its influence on the fatigue properties
Mechanical and fatigue properties of material are dependent on its microstructure. The microstructure of AISI 316L stainless steel commonly used for the production of medical tools, equipment and implants can be easily i...
EVALUATION OF DIELECTRIC CURING MONITORING INVESTIGATING LIGHT-CURING DENTAL FILLING COMPOSITES
The aim of this study is the evaluation of a dielectric analysis (DEA) method monitoring the curing behaviour of a light curing dental filling material in real-time. The evaluation is to extract the influence of light in...