Studies on Improvement of Performance of Compression Ignition Engine Fuelled with Mixture of Honge Biodiesel and Tire Pyrolysis Oil
Journal Title: Strojnicky casopis - Journal of Mechanical Engineering - Year 2018, Vol 68, Issue 1
Abstract
The biodiesel has lower volatility and is costlier than the fossil diesel. Hence it is necessary to add a low cost fuel which has higher volatility, with the diesel. The tire pyrolysis oil (TPO) produced from waste tire and tubes have these desirable properties and hence in this work, we have mixed TPO with biodiesel to enhance the properties of the biodiesel. The engine tests were carried out on a single cylinder compression ignition engine with the mixture of biodiesel and TPO as fuel. From the engine tests, it is observed that the fuel mixture results in engine performance close to diesel operation at the higher injector nozzle opening pressure.
Authors and Affiliations
Natesan Kapilan and Naik Jullya
Neural Networks - A Way to Increase the Fuel Efficiency of Vehicles
This paper deals with the possibility of creating a vehicle model using a hierarchy of neural networks. Based on this model, it is possible to build an optimization cycle that looks for parameters which are influencing...
Thermal Characteristics of High Temperature Naturally Circulating Helium Cooling Loop
The paper deals with the process properties in terms of the heat transfer, i.e. the thermal performance of the thermal-process units within a helium loop intended for the testing of the decay heat removal (DHR) from th...
Effect of Tapered Interference Fit between Impeller and Shaft in Turbo Machines
In Turbo machines, there are many components which are provided with interference to transmit torque and to maintain contact between them. There are transient scenarios where impeller and shaft lose interference and li...
The Calculation of the Contact Force and the Contact Width of Shaft Seals
The aim of the article is to point out the sealing efficiency of the two-language seal of the water pump bearing when radially deflecting the shaft within radial clearance. In order to obtain a radial displacement of th...
Modeling of Coolant Flow Within the Spent Fuel Storage Pool of a VVER 440 Reactor
The article deals with modelling of coolant flow within the spent fuel storage pool of a VVER 440 reactor. The spent fuel storage pool is modelled in a state of standard reactor operation. The coolant heating from the...