Study on Breaking Load of Single Lap Joint Using Hybrid Joining Techniques for Alloy Steel AISI 4140 and Mild Steel: Taguchi and Neural Network Approach
Journal Title: Strojnicky casopis - Journal of Mechanical Engineering - Year 2018, Vol 68, Issue 1
Abstract
The present investigation carried out to analyze the breaking load of single lap joint using hybrid joining techniques for alloy steel AISI 4140 and mild steel as base material by experimentally and optimized by Taguchi method and neural network. The six samples of lap joints were prepared namely: bolted joint (BJ); adhesive joint (AJ); welded joint (WJ); bolted-welded joint (BWJ); adhesive-welded joint (AWJ) and adhesivebolted joint (ABJ). The breaking load of the joints in terms of breaking load and elongation were evaluated for each joint. The effect of the adjustment attached to the joint on the breaking load and elongation were evaluated. Taguchi method was applied for given input parameters and L4 design of experiments was used. The breaking load and elongation were taken as output response. The predicted values by Taguchi method were used as target values in neural network fitting curve. Neural network fitting tool was used to check whether the obtained values were near the target value or not. Based on the achieved results, the maximum breaking load and elongation were found for bolted-welded joint.
Authors and Affiliations
Prasad Lalta and Khantwal Rahul
Keywords
Related Articles
- EP ID EP43927
- DOI https://doi.org/10.2478/scjme-2018-0005
- Views 185
- Downloads 0
Effect of Dry Friction on Bifurcation Diagram of Furuta Pendulum
Traditionally, the Furuta pendulum was used for testing advanced control strategies on a simple nonlinear and underactuated structure. In this paper, we investigate analytically and experimentally the dynamical descrip...
Frequency Response Function Measurement on Simplified Disc Brake Model
The paper describes role of non-proportional damping in flutter type instability, demonstrated on simplified disc brake model. The discrete two degrees of freedom system is considered to imply damping induced instabili...
The Effects of Piezoelectricity Matrix Constants on the Charge of a Thin Membrane
This article is devoted to the comparison of the influence of the piezoelectric matrix properties on the magnitude of the resulting charge when a thin piezoelectric membrane of circular cross section, made from alumini...
Analysis of Mechanical Properties of the “Bearing” Part Based on Polished Samples
Presented work describes the use of algorithm for the computation of thermo-elastic properties of randomly reinforced composite which is based on histogram from image analysis done on ITAM, CAS. Three polished samples...
Rooppur Nuclear Power Plant: Current Status & Feasibility
In the present world, nuclear energy is a must need for various purposes. The main cause of nuclear energy is because of the increasing energy demand, which is not possible to provide by using convenient energy generat...