The barrier height (BH) and ideality factor (n) distribution in identically prepared Al/ Bi3Ti4O12/n-Si (MFS) structures
Journal Title: Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji - Year 2017, Vol 5, Issue 3
Abstract
In this study, the values of barrier heights and ideality factors of identically fabricated Au/BTO/n-Si (MFS) type SBDs (60 dots) have been obtained from their intercepts and slopes linear parts of forward bias lnI vs V plots at room temperature. Experimental results show that these two important parameters (BH and n) of the diodes change from diode to diode even if they are identically prepared on same quarter n-Si wafer. These results are clearly important to understand the physical origin of such non-ideal behavior so that it can be controlled in future such device applications. High values of n can be attributed to the existence of a wide distribution of low Schottky barrier height (SBH) patches, interfacial BTO layer and surface states. According to us, the BH differences over the contact area are a result of inhomogeneity interfacial layer thickness or composition and BH between metal, grain boundaries and semiconductor and non-uniformity of the interfacial charges or dislocations.
Authors and Affiliations
Hayriye Gökçen ÇETİNKAYA
Keywords
Related Articles
- EP ID EP484325
- DOI -
- Views 92
- Downloads 0
A Multi Objective Genetic Algorithm Approach for The Solution of Vehicle Routing Problem with Time Windows
In this study, Vehicle Routing Problem with Time Windows (VRPTW) which is a type of classical Vehicle Routing Problem (VRP) includes customers with known demands, a single depot with known location and a certain number o...
Synthesis and Characterization Studies of New Generation MIL-101 Materials
MIL-101, a kind of Metal Organic Frameworks (MOFs), has attracted attention in recent years with its promising applications in the chemical industries. MIL-101 is also known as “Porous Chromium Terephthalate”. It has ver...
Back Stretching Behaviors in V Bending
The springback is difference between the die geometry and bended sheet geometry. This phenomena is a general shaping problem in sheet metal forming. In V bending, the numerous factors such as material (material type, thi...
Comparing Crisp and Fuzzy DEA Approaches for The Launch Vehicle Selection Problem of A Communication Satellite Operator
In space industry, launch vehicle selection for a satellite is a critical managerial and technical decision making problem. Depending on the selected launch vehicle, launch cost can vary from 20 % to 50 % of the total co...
The Investigation of viscosity values of Aluminum Powder Reinforced Polypropylene.
In this study, aluminum (Al) powder reinforced polypropylene based composites were produced and viscosity changes were investigated for the determination of flow properties of composites. Experiments have been carried ou...