THE IMPACT OF BIODEGRADABLE CUTTING FLUID ON THE TRIBOLOGICAL PROPERTIES OF THE FRICTION PAIRS
Journal Title: Tribologia - Year 2016, Vol 265, Issue 1
Abstract
This paper discusses the results of wear tests performed with a T-01 M tribometer for a ball-on-disc configuration in sliding contact. The tests were carried out for HS6-5-2C steel discs with and without a TiAlN coating deposited by physical vapour deposition (PVD), which were in contact with 100Cr6 steel balls. The tests were conducted under dry friction conditions and under lubricated friction conditions with a cutting fluid containing zinc aspartate. The coating structure was observed using a JSM - 7100F scanning electron microscope. The surface texture of the discs and the balls was analysed as well as good adhesion to the substrate. Coated tools can operate under dry and wet machining conditions, and they improve the operating parameters of the element. Such coatings can be produced by chemical vapour deposition (CVD), physical vapour deposition (PVD), or similar techniques [L. 8, 4, 13].<br/><br/>
Authors and Affiliations
Dariusz OZIMINA, Joanna KOWALCZYK, Monika MADEJ
Keywords
Related Articles
- EP ID EP248230
- DOI 10.5604/01.3001.0010.7581
- Views 61
- Downloads 0
TRIBOLOGICAL PROPERTIES OF THE PLASTICALLY CONSOLIDATED ALUMINIUM POWDERS
The results of the tribological tests performed on the aluminium (1070 grade) produced by rapid solidification and plastic consolidation powders are presented in the article. The results were compared to solid aluminium...
TRIBOLOGICAL PROPERTIES OF COMPOSITE COATINGS ON ALUMINIUM ALLOY PARTS FOR TRANSPORT MEANS
The present paper describes the structure, surface topography, and tribological properties of a DLC composite coating produced by magnetron sputtering on an engine cylinder liner AC-AlSi12NiCuMg (AC-47000) cast alloy as...
POSSIBILITIES OF SHAPING THE WEAR RESISTANCE OF THE LASER BORONIZED SURFACE LAYERS ON MACHINE PARTS PRODUCED WITH STEEL AND CAST IRON
This paper presents the importance of laser techniques in shaping parts of surface layers with cast iron and steel. Laser boronizing was carried out using a CO2 laser with a nominal power of 2600W for multiple tracks. La...
TRIBOLOGICAL CHARACTERISTICS OF MATERIALS INTENDED FOR FOIL-AIR BEARINGS ELEMENTS
In the paper, the tribological research results of materials intended for foil-air bearings are presented. Two tested types of foil, intended for high-speed foil bearings, were provided by the Institute of Electronic Mat...
TRIBOLOGICAL RESISTANCE INCREASE OF CAST IRON CYLINDER BRUSH SURFACE LAYER WITH THE APPLICATION OF LASER ABLATION TREATMENT
Results of preliminary laboratory and technology tests of cast iron after laser modification are presented in the paper. In order to improve macro- and micro-geometry of the upper layer of cylinder sliding surface, a las...