TRIBOLOGICAL WEAR OF A COMPOSITE–COMPOSITE SYSTEM IN THE PRESENCE OF DIFFERENT ABRASIVE MATERIALS

Apply

TRIBOLOGICAL WEAR OF A COMPOSITE–COMPOSITE SYSTEM IN THE PRESENCE OF DIFFERENT ABRASIVE MATERIALS

Journal Title: Tribologia - Year 2012, Vol 244, Issue 4

Abstract

The article presents the results of abrasive wear resistance of metal–polymer thermo- and chemosetting composites in composite–composite tribological system. To make the comparison, some friction experiments were performed using a steel–bearing alloy system. During the research, two kinds of regenerative chemically setting composites were used. The cross-linking agents used were amine compounds with different chemical structure and reactivity (such as triethylenetetramine and adduct of aliphatic and aromatic amines). These cross-linking agents made it possible to obtain composites with very different mechanical properties. Electrocorundum and silica of defined chemical and granulometric composition were adopted as abrasive material. Chemosetting metal–polymer composites were applied to a steel roller and machined to the desired size to cooperate with a bronze block and metal-polymer composite based on thermosetting phenol- -formaldehyde resin. The friction tests were performed using a T-07 block- -on-ring tester in the presence of the selected abrasive material. Tribological tests were conducted at a speed of 0.1 m/s and 1 MPa pressure, without any lubricant. A high resistance to abrasive wear of the tested systems was proved, which means they can be used for machine element regeneration that are running in an abrasive environment.

Authors and Affiliations

Zbigniew Pawelec

Keywords

GEOMETRIC STRUCTURE OF THE GEAR TEETH SIDE SURFACES AND THE PROCESS OF FATIGUE WEAR

This study investigates the geometric parameters of the gear teeth side surfaces, formed in the final stage of manufacturing and processing and their influence on the fatigue wear of the surface. Tests were run on gear t...

LABORATORY INVESTIGATIONS OF WEAR RESISTANCE UNDER FRICTION OF A SURFACE LAYER OF 41CrAlMo7 STEEL AFTER GLOW DISCHARGE NITRIDING AS WELL AS ABLATION LASER TEXTURING

The paper presents the results of laboratory investigations including measurements of selected parameters in the node of friction (temperature, friction force, wear resistance) with the use of the measured line method fo...

EP ID EP270464
DOI -
Views 46
Downloads 0