THE INFLUENCE OF METALLIC FILLER ON THE CROSS-LINKING OF EPOXY COMPOSITES AND THE FORMATION OF THEIR TRIBOLOGICAL PROPERTIES
Journal Title: Tribologia - Year 2011, Vol 236, Issue 2
Abstract
The paper presents tribological tests results of chemically setting composites with different qualitative compositions. The polymer matrix of composites was epoxy resin Epidian 5. Powders of bronze, brass, copper, and iron with a specific chemical composition and grain size were used as composite fillers. Composites were cross-linked with aliphatic polyamines at room temperature. T-05 black-on-ring tester measured the tribological characteristics of different material junctions in conformal contact. A steel roller coated by cross-linking and machined to the desired size chemically setting metal-polymer composite was cooperating with a chemically setting composite based counter specimen. The composite – composite conjunction with iron powder filler shows a low friction coefficient and high resistance to wear. The results obtained by infrared spectroscopy showed that the degree of cross-linking of epoxy matrix composites depends on the type of metallic filler.<br/><br/>
Authors and Affiliations
Zbigniew Pawelec, Jarosław Molenda, Marek Wolszczak
Keywords
Related Articles
- EP ID EP271785
- DOI -
- Views 54
- Downloads 0
EXPERIMENTAL RESEARCH ON GAS FOIL BEARINGS WITH POLYMER COATING AT AN ELEVATED TEMPERATURE
As demand for high-performance fluid-flow machines (including micro-turbines) increases across the globe, new non-conventional bearing systems are needed. In the last years, specialized technical solutions involving the...
STRESS IN CONTACT OF TEETH GEAR WITH COATED MATERIAL
Due to the increased interest amongst tooth gear manufacturers for an adequate method of stress field controlling, this paper presents an analysis of the applicability of Hertz theory to the case of contact of the elemen...
TRIBOLOGICAL PROPERTIES OF BLACKBERRY WASTE SEED EXTRACT OBTAINED UNDER SUPERCRITICAL CO2 CONDITIONS WITH SORBITAN ESTERS COMPOSITONS
This paper presents results of tribological research of a composition containing as a base, extract of waste blackberry seeds obtained by extraction under supercritical carbon dioxide conditions with sorbitan esters as a...
TRIBOLOGICAL CHARACTERISTICS OF MATERIALS INTENDED FOR FOIL-AIR BEARINGS ELEMENTS
In the paper, the tribological research results of materials intended for foil-air bearings are presented. Two tested types of foil, intended for high-speed foil bearings, were provided by the Institute of Electronic Mat...
Ocena własności tribologicznych nowych materiałów narzędziowych na osnowie niklu
W niniejszej pracy przedstawiono nowe materiały na osnowie niklu umacniane związkami faz międzymetalicznych o dużej zawartości węgla. Skład chemiczny nowych materiałów zaprojektowano tak, aby umocnienie osnowy uzyskać w...