The influence of sigma phase on erosion and corrosion properties of duplex steel
Journal Title: Archiwum Odlewnictwa - Year 2010, Vol 10, Issue 3
Abstract
The paper presents the results of investigations concerning the influence of σ phase precipitating on the erosion and corrosion properties of ferritic-austenitic cast steel. The object of investigation have been two grades of corrosion-resistant cast steel: GX2CrNiMoCuN25-6-3-3 and GX2CrNiMoN25-6-3. The examinations have involved measurements for obtaining potentiodynamic curves, examination of erosion and corrosion resistance, and microstructural analysis. The supersaturated cast steel and the material after heat treatment have been examined. It has been found that the tribological properties of supersaturated cast steel are worse than those of the supersaturated and annealed cast steel. The highest erosion and corrosion resistance has been achieved as a result of ferrite decomposition δ → γ’+ σ. The examinations of corrosion resistance have revealed that the ageing process after supersaturation do not cause significant changes in the anti-corrosive properties.
Authors and Affiliations
Z. Stradomski, A. Brodziak
Application of time-series analysis in foundry production
Characterization of the time-series analysis is presented, as a data mining tool which facilitates better understanding nature of manufacturing process and permits forecasting of future values of the process parameters o...
MAGMAsoft simulation applied in verification of technology to produce new range of alloy steel castings
The article presents the results of MAGMAsoft application in simulation of the pouring and solidfication of castings made from GS20Mn5 steel, basing on some principles adopted in the starting technology. The results of s...
Preliminary Research on Granulation Process of Dust Waste from Reclamation Process of Moulding Sands with Furan Resin
The results of investigations of the granulation process of foundry dusts generated in the dry mechanical reclamation process of used sands, where furan resins were binders are presented in the paper. Investigations conc...
Heat-insulating moulding sand with the glycol addition
The article presents a selection of the composition and basic properties of highly insulating moulding sand. Sandmix is designed especially for thin-walled castings with high tendency to oxidation - particularly in spati...
The influence of microstructure on the mechanical properties of metallurgical rolls made of G200CrMoNi4-3-3 cast steel
The subject of the study is the high-carbon tool cast steel G200CrMoNi4-3-3 used for metallurgical rolls, especially in section rolling mills. The test material was derived from a roll damaged in production; therefore, t...