THE ROLE OF MOTION MONITORING IN EXPERIMENTS ON SLIDING FRICTION IN FLAT-ON-FLAT METALLIC CONTACTS
Journal Title: Tribologia - Year 2017, Vol 276, Issue 6
Abstract
The paper describes an example of an experiment on sliding friction of metallic materials in which vibration measurement methods were used to identify friction induced vibrations occurring in sliding. The determination of the parameters of the motion of the critical components in the sliding system in different modes of operation allowed using the vibration signal as a source of information pertaining to the observed process. The tests performed with a metallic material were inspired by the earlier research performed with machine ceramics in which the result of vibration analysis allowed the determination of the correctness of measurement with regard to the conditions of contact and the analyses of the nature of the observed effect of vibration on the inflicted friction. The motion analysis data was used as a basis for a screening method eliminating corrupted measurements from the data set used for global evaluation of the friction characteristics. It was confirmed that, in a steel-on-steel sliding system, similar friction and vibration regimes occur as in ceramics-on-ceramics, but the effects of certain vibration modes are opposite in the two systems, despite the same load/velocity conditions.
Authors and Affiliations
Jacek ŁUBIŃSKI
Keywords
Related Articles
- EP ID EP254808
- DOI 10.5604/01.3001.0010.8057
- Views 75
- Downloads 0
THE EFFECT OF UNEVEN LOAD DISTRIBUTION ALONG THE MESHING OF THE TEETH CONTACT STRESS
The paper presents issues concerning the contact stresses occurring in the surface layer of the teeth of gears. We analysed the gears found in the actual gear used in the drive wheel loaders and crawler tractors. Enginee...
Wpływ dodatku krzemu do dwuwarstwowych powłok typu (Cr,Si)N/TiN na ich właściwości mikromechaniczne i tribologiczne
W pracy analizowano wpływ zawartości krzemu na właściwości mikromechaniczne dwuwarstwowych powłok (Cr,Si)N/TiN osadzonych na płytkach z węglików spiekanych. Międzywarstwę TiN o grubości ok. 4 m nałożono metodą łukową, a...
LUBRICATION STABILITY AND OXIDATION STABILITY OF MODIFIED GREASES
This article presents the results of the oxidation stability and service life of greases prepared with and without the addition of modifiers. The effectiveness of the additives used in the grease was calculated based on...
CHANGES IN THE CHEMICAL COMPOSITION OF A STEEL SURFACE DURING FRICTION
The primary objective of this work was to investigate the chemical composition of the sliding surfaces during tribological tests with the participation of lubricants based on mineral oil SAE 30/95 and selected AW/EP addi...
FINISHING OF FLAME SPRAYED Ni-AL COATINGS AND AN ESTIMATE OF CBN INSERT WEAR
Highly accurate finishing of flame spraying Ni-5%Al coatings was carried out using sliding turning by tool with CBN cutting inserts. Flank (VB) and attack (KB) wear indexes of square and trigonal cutting inserts while ma...