THE TRIBOLOGICAL PROPERTIES OF PLASMA SPRAYED AL2O3 CERAMIC COATINGS
Journal Title: Tribologia - Year 2014, Vol 253, Issue 1
Abstract
The article presents the tribological properties of plasma sprayed coatings based on ceramic powder Al2O3 and Al2O3 powder with the addition of 4% Mo. Coating tests were carried out in combination with a C45 steel using Amsler A 135 friction and wear tester in dry and mixed friction conditions. Tribosystems were lubricated with gear oil Shell Spirax S2 A 80W-90 used in drilling devices for oil and gas. The effect of the coating type and the type of friction on the tribological properties of the coatings tested was demonstrated. The best tribological properties were obtained for the Al2O3 coating with the addition of 4% Mo.
Authors and Affiliations
Stanisław LABER, Alicja LABER, Agnieszka LABER
Keywords
Related Articles
- EP ID EP263768
- DOI -
- Views 61
- Downloads 0
WEAR AS THE CRITERION OF EVALUATION OF LUBRICANT INFLUENCE ON A TRIBOLOGICAL SYSTEM
The author presents the method and the results of investigations concerning wear measurement value of a kinematic couple as the criterion of the evaluation of lubricant influence on a tribological system.<br/><br/>
ANTIWEAR PROPERTIES OF AMORPHOUS a-Si:C:H LAYERS ON PHOTOVOLTAIC CELLS
The amorphous hydrogenated silicon–carbon (a-Si:C:H) layers have been applied as the antireflective coating (ARC) in solar cells. The layers of 100 nm thickness were obtained on multi-crystalline (multi- Si) and mono-cry...
EXPERIMENTAL METHOD OF DETERMINING THE MAGNETIC SUSCEPTIBILITY COEFFICIENT c FOR FERRO-OILS WITH DIFFERENT CONCENTRATIONS OF MAGNETIC PARTICLES
This paper presents the construction of an experimental test bench to determine the magnetic susceptibility coefficients χ of ferro oils with different concentrations of magnetic particles, and also the analysis of the r...
WPŁYW TECHNOLOGII FORMOWANIA OTWORÓW NA DESTRUKCJĘ MATERIAŁU DD11 STOSOWANEGO NA TARCZE OBRĘCZY KOŁA
W pracy przedstawiono wyniki badań porównawczych procesu destrukcji próbek wykonanych z materiału DD11, dla których zastosowano różne technologie formowania otworów w postaci wiercenia i wykrawania. Do analizy właściwośc...
Wpływ wybranych napełniaczy stosowanych w kompozytach PTFE na współczynnik tarcia statycznego po stali
Tarcie statyczne odgrywa istotną rolę przy wyznaczaniu podczas projektowania całkowitych oporów ruchu elementów maszyn pracujących cyklicznie, zwłaszcza tych, które realizują ruch posuwisto-zwrotny. Straty tarcia w tego...