THE USE OF BIODEGRADABLE CUTTING FLUID FOR THIN AND HARD a-C:H AND TiAlN COATINGS
Journal Title: Tribologia - Year 2017, Vol 276, Issue 6
Abstract
This paper presents results of tribological tests performed under lubricated friction conditions using a T-01M analyser. The lubricant was biodegradable cutting fluid containing a special-purpose additive – zinc aspartate. The discs for the ball-on-disc configuration were made of HS6-5-2C steel. The study involved testing coated and uncoated steel specimens. The a-C:H and TiAlN coatings were produced using physical vapour deposition (PVD). The structure of the coatings was analysed before and after the tribological tests with a JSM-7100F scanning electron microscope. The coating hardness was measured using a CSM Instruments nano-hardness tester (NHT). The coating surface texture of the coated and uncoated discs was determined by means of a Talysurf CCI Lite profilometer. The thin boundary films that formed in the friction area prevented the surfaces from coming into direct contact. The films improved the motion resistance and provided anticorrosive protection during the tests. The biodegradable cutting fluid used in the study had no negative effect on the environment.
Authors and Affiliations
Monika MADEJ, Joanna KOWALCZYK, Andrzej KULCZYCKI, Dariusz OZIMINA
Keywords
Related Articles
- EP ID EP254809
- DOI 10.5604/01.3001.0010.8058
- Views 69
- Downloads 0
LABORATORY STAND FOR TESTS OF SLIDE BEARINGS BASED ON HEAT BALANCE
In the paper design of the laboratory test stand for slide bearings tests based on heat balance is presented. The description of friction torque and temperature measurement systems installed on the stand are given. The s...
WPŁYW ZMIENNOŚCI WYBRANYCH PARAMETRÓW NA NIEZAWODNOŚĆ ŁOŻYSKA WZDŁUŻNEGO TURBINY WODNEJ
Ślizgowe łożyska wzdłużne zbudowane są z wahliwie umocowanych segmentów. Jednym z rozwiązań jest posadowienie segmentów na zespołach sprężyn. Parametry techniczne sprężyn są zmiennymi losowymi. Zmienność ich wartości moż...
THE ANALYSIS OF THE SLIPPAGE AND CONTACT STRESS IN THE MESHING OF THE POWER-SHIFT TYPE GEAR
This work is an analysis of gear slippage and contact stresses in toothed gears of a six-shaft power shift gearing. Gear meshing contains 5 characteristic contact points located within the active surface of a tooth. The...
THE ANALYSIS OF BIOMECHANICAL STATE IN A HIP JOINT AFTER COMPLETE ALLOPLASTICS WITH DIFFERENT VARIANT OF CEMENTLESS ENDOPROSTHESIS
Modelling and simulation of the stress distribution and displacements in the applications with cementless endoprosthesis of a hip joint were carried out. The analysis subjected biobearings with cups of layered structures...
ODPORNOŚĆ NA ZUŻYCIE STALI KONSTRUKCYJNYCH W EFEKCIE OPERACJI BOROWANIA
W publikacji przedstawiono wyniki badań wpływu obróbki cieplno-chemicznej, borowania i składu chemicznego wybranych stali konstrukcyjnych na zużycie w procesie tarcia ślizgowego. Operację borowania stali gatunku C45, 37C...