Thermoluminescence Properties of Quartzite Rock after β-irradiation
Journal Title: Cumhuriyet Science journal - Year 2018, Vol 39, Issue 4
Abstract
In the present study, the thermoluminescence characteristics of natural quartzite collected from Karaisalı (Adana) in Turkey were investigated after β irradiation at room temperature with the purpose to use as radiation dosimetry. The glow curve of quartzite mineral shows two peaks at 110 oC and 250 oC and a shoulder at 375 oC, explicitly. The resulting peaks, which were examined using the computer glow curve deconvulation (CGCD) method, were deconvuluted and kinetic parameters (activation energy Ea, frequency factor (s) and kinetic degree (b)) were determined. After CGCD methods, it was seen that the glow curve suporposed at least eight peaks. Additionally, kinetic parameters were determined using by Arrhenius plot obtained from initial rise (IR) method. In this study, it is shown that there is a correspondence between kinetic parameters calculated by IR method and peaks deconvoluated by CGCD technique in low temperature region (P1-P3). Additionally, reusability test was conducted to investigate its usability as a dosimetric material, and a change of 2% was observed in the results of 10 repeated times. Besides to the characterization of this sample X-ray diffraction (XRD) and scanning electron microscopy (SEM) - energy dispersive X-ray (EDX) results were investigated.
Authors and Affiliations
Tamer DOĞAN
Keywords
Related Articles
- EP ID EP488426
- DOI 10.17776/csj.435527
- Views 90
- Downloads 0
Examination of Rheological Behavior of Water-Based Graphene Oxide Nanofluids
In this study, the rheological properties of nanofluids obtained by loading of Graphene oxide nanoparticles produced by the improved Hummers method into the deionized water base fluid in a mass fraction range of 0.1-1% w...
Effects of Cerium, Iron and Copper Incorporation on the Structural Properties and Activities of Ti-Pillared Bentonites
Ti-pillared bentonite (Ti-PB) using bentonite from the Middle Anatolia region (Hançılı) was synthesized. Iron or copper was impregnated to Ti-PB from the solution and subsequent cerium incorporation was done by wet impre...
Optimization of Molding Unused New Sand Composition by Mixture Design Method
In this study, various parameters which affect the green strength, gas permeability and shear strength of unused casting sands were investigated in order to improve the quality of casting sands used in Estaş casting foun...
The Fluorescence Intensity Ratios of Superconducting FeySe1-XTeX Thin Films
Superconducting thin films of FeySe1-xTex were grown on to the single crystal MgO substrates by RF sputtering and the effects of processing conditions on the microstructural development were investigated. Besides, the fl...
Ambarzumyan Type Theorems for a Class of Sturm-Liouville Problem
In this paper, we prove Ambarzumyan type theorems for an impulsive Sturm–Liouville problem with eigenparameter in the boundary conditions.