Tissue Processor Based Programmable Logic Control
Journal Title: Journal of Electronics, Electromedical Engineering, and Medical Informatics - Year 2019, Vol 1, Issue 1
Abstract
Tissue Processor Tissue Processor consists of several stages of dehydration, clearing, and paraffin infiltration. Phase dehydration to remove water content in tissues by immersion into alcohol. Clearing stage is the process of pulling out the alcohol content in the network by using a liquid xylol. Paraffin infiltration stages are the stage of filling cavities with liquid paraffin tissue. The purpose of this research is to modify the equipment that had broken before became useful equipment that uses basic controlled PLC. This modification tool-making using the one-group posttest design by treatment of the instrument without first measuring the initial state, the results of treatment directly measured without comparison to a control group. Making the modification tool using PLC as the main controller throughout the series. The tool mechanical motion using DC motors and AC motors as well as the use of two sensors limit switch as the controller limits the motor movement. Based on the results obtained temperature measurement error with the largest value of 4.44% in paraffin heater tube 1 and the biggest error of 4.0% in paraffin heater tube 2. While the measurement time of each - each tube obtained the smallest error on the tube-to-one by 0.03%, and the biggest error of measurement contained in the tube to the fourth, fifth, sixth, eighth and tenth of 0.16%
Authors and Affiliations
Neny Ferdianita, Her Gumiwang Ariswati, Tribowo Indrato
Keywords
Related Articles
- EP ID EP614907
- DOI 10.35882/jeeemi.v1i1.5
- Views 88
- Downloads 0
Phototherapy Radiometer with AS7262 Sensor
The phototherapy is a device used in hyperbilirubinemia therapy by using blue light radiation with ranges between 425nm-475nm. The effectiveness of hyperbilirubinemia therapy depends on the amount of energy emitted by li...
Tissue Processor Based Programmable Logic Control
Tissue Processor Tissue Processor consists of several stages of dehydration, clearing, and paraffin infiltration. Phase dehydration to remove water content in tissues by immersion into alcohol. Clearing stage is the proc...
Electrosurgery Unit Monopolar Equipped with Cutting and Coagulation Function
Electrosurgery Unit is a medical device that utilizes high frequency and voltage used to cut and dry tissue during the surgical process. The purpose of making this tool is to damage certain body tissues by heating the ti...
Portable Pulse Oximeter
Pulse oximeter is a tool to monitor oxygen saturation in the blood (arteries) and also a person's heart rate (BPM) without having to go through blood analysis. Lack or excess of oxygen in the blood will cause illness and...
The Design of Oxygen Concentration and Oxygen Flow Rate in Continuous Positive Airway Pressure
Measuring oxygen concentration and measuring the flow of oxygen is a tool used to measure the percentage of oxygen content and oxygen flow rate in CPAP. This tool uses the OCS-03F sensor, with Arduino NANO processors the...