Tribological study of low friction DLC:Ti and MoS2 thin films
Journal Title: Journal of Achievements in Materials and Manufacturing Engineering - Year 2018, Vol 1, Issue 89
Abstract
Purpose: The purpose of this article is to characterize and compare the microstructure and tribological properties of low friction DLC:Ti and MoS2 thin films deposited on the austenitic steel X6CrNiMoTi17-12-2 substrate. Design/methodology/approach: In the research, the samples of the DLC:Ti and MoS2 thin films deposited by PACVD technology and magnetron sputtering method respectively were used. Observations of topography were made using atomic force microscope (AFM). Adhesion of the coating to the substrate material was verified by the scratch test. The friction coefficient and wear rate of the coating were determined in the ball-on-disc test. Findings: AFM as well as adhesion and friction coefficient tests confirmed low friction nature of MoS2 and DLC:Ti coatings. During the research information on the behaviour of coatings under tribological load was obtained. The investigated coating reveals high wear resistance and good adhesion to the substrate. Practical implications: The area of testing of low-friction thin films is widely studied due to their practical application. Intensive development of new technologies requires the introduction of corresponding layers of both full protective functions and reducing friction. Originality/value: Growing area of low-friction coatings with specific properties requires thorough tribological and topographical research, which is closely related to these properties.<br/><br/>
Authors and Affiliations
A. Paradecka, K. Lukaszkowicz
Keywords
Related Articles
- EP ID EP399482
- DOI 10.5604/01.3001.0012.6667
- Views 103
- Downloads 0
Advances in winch system for defence applications
Purpose: Winch systems are commonly used in many applications starting from fishingindustries to highly advanced defence, space and nuclear sectors. This paper discussesadvances in development of winch system for defence...
Power control of a wind energy based on a DFIG by sliding mode approach and pitch angle optimal control by genetic algorithm
Purpose: In this paper, a regulate of a variable wind energy conversion system, based ona doubly fed induction generator DFIG is proposed, the system we considered is controlledto generate maximum energy while minimizing...
Surface topology of friction pairs of A390.0 alloys
Purpose: In the paper, geometric structure of the surface of A390.0 alloy, manufactured using various methods are presented, in combination with EN-GJL-350 cast alloy, which corresponds to parameters used in combustion e...
The effect of colemanite addition on the properties of mullite-zirconia composites prepared by slip casting
Purpose: This study deals with the effects of colemanite (Ca2B6O115H2O) on properties ofslip-cast mullite–zirconia composites prepared via reaction–sintering of kaolinite, aluminaand zircon powders.Design/methodology/app...
Microstructure and properties of cold sprayed composite coatings
Purpose: The composite coatings containing incorporated ceramic achieve a wide spectrum of enhanced properties, resulting from a combination of features from a ductile matrix and hard particles. This article attempts to...