Vector Control of Asynchronous Motor with Two-mode Controller
Journal Title: 河南科技大学学报（自然科学版） - Year 2017, Vol 38, Issue 4
Abstract
Aiming at the poor anti-interference of proportional integral ( PI) control and modal chattering of fuzzy sliding mode variable structure control, a two-mode controller was proposed to control the speed of asynchronous motor vector control system, and the fuzzy sliding mode variable structure controller was designed. The fuzzy sliding mode variable structure controller was combined with PI controller. Thus, the two-mode controller was got and the selecting principle of threshold value was given. The simulation results show that this method not only increases the resistance to load disturbance of the system, but also eliminates the modal chattering nearly. The feasibility of two-mode control in the asynchronous motor vector control system is verified.
Authors and Affiliations
Ligang ZUO, Danhong ZHANG, Yixin SU, Yuepeng CHEN
Keywords
Related Articles
- EP ID EP478104
- DOI -
- Views 66
- Downloads 0
Designe of Multi-Parameter Water Quanlity Sensor
In order to simplify the transmission line of water quality sensor and improve the measurement accuracy of conductivity and pH parameters, single-core cable structure, six-layer stacking mode and single-end input mode we...
Performance of Jet Refrigeration Cycle Using R1234yf as Alternative Refrigerant
The jet refrigeration cycle with refrigerant R134 a could obtain high cycle performance,but it would gradually be restricted or be substituted by environment-friendly refrigerants due to its high global warming potential...
Basic Mechanical Properties Experiment on Lithium Slag Polypropylene Fiber Reinforced Concrete
In order to study the mechanical properties of polypropylene fiber reinforced concrete containing lithium slag,16 groups of concrete specimens with different replacement rates of lithium slag and different contents of po...
Failure Criterion of Scrap Tire Rubber Pads Under Axial Compression
In order to further clarify the failure behavior of scrap tire pads ( STP) under pure pressure state, a more accurate criterion of axial compressive failure was proposed. The horizontal 6-layer STP of 180 mm × 180 mm was...
Effects of Annealing Treatment on Microstructures of Cu-Mo Alloy Films
Cu-Mo alloy thin films were deposited on flexible polyimide ( PI) substrate by magnetron sputtering method.The Cu-Mo alloy thin films were annealed in situ vacuum at different temperatures. The composition, phase structu...