A Novel Visual SISO and MIMO Computer Interface for Process Production System
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 2
Abstract
Computer based automation systems have found a wide range of applications in manufacturing and processing industries. To interface computer and control system, various standard industrial interfaces were used. Because of its complexity and high cost in some places, a custom model was built by a person having broad knowledge of computer and control system. Later on visual patterns based computer interfacing was introduced. This used less hardware when compared to the standard model. To further reduce its hardware complexity, in this paper, a modified vision based computer interfacing is introduced for single input single output (SISO) systems. This technique is further extended for multiple inputs and multiple output systems (MIMO). The working of the proposed interface modules were tested with the help of computer control based SISO conical liquid tank system and MIMO heat exchanger system
Authors and Affiliations
MANIKANDAN C, NEELAMEGAM P, RAKESH KUMAR S, SAI SIVA SATWIK. K
Keywords
Related Articles
- EP ID EP347161
- DOI 10.24247/ijmperdapr201820
- Views 77
- Downloads 0
Comparison of Power Output’s of Different Blends of Pyrolysis Plastic Oil & Diesel with Pure Diesel on Single Cylinder 4-S (VCR) Diesel Engine
An experimental study was conducted, to compare the powers outputs of pure diesel with different blends of Pyrolysis plastic oil and diesels. Waste plastic through thermal treatment can be derived into liquid fuel or was...
ANALYSIS AND EVALUATION OF MACHINING RESPONSES DURING HARD TURNING OF EN353 STEEL
Estimation, prediction and analysis of responses in turning operation is one of the key research areas. This paper studies the performance of coated inserts (PVD and CVD) in hard machining. In this analysis, 27sets of ha...
Optimization of Process Parameters in Turning Operation of Austenitic Stainless Steel Rod using Taguchi Method and ANOVA
This research paper is an outcome of investigation made on the parameters those affects on austenitic stainless steel work piece roughness in the turning operation as a part of that the parameters involved in the operati...
Influence of Segregation on the Rheological Behavior of Cement Grouts Determined by Coaxial Cylinder Rheometer
This work aims to study the phenomenon of segregation during the rheological characterization tests and influence of this phenomenon on the rheological behavior of cement grout. Thanks to a new methodology composing a sp...
Assessment of RNG k-ε, SST K- ω and Reynolds Stress Models For Numerical Simulation of DLR Scramjet Engine
In recent years, many researchers have used numerical simulation to investigate scramjet engine because, setting up of testing facilities for scramjet engine is very expensive. Completion of simulation work in less time...