Alternative Energy Source for Heating System of Woodworking Enterprise
Journal Title: Energy Engineering and Control Systems - Year 2018, Vol 4, Issue 1
Abstract
At woodworking enterprises, there is a large amount of wood waste the energy potential of which can be used as an alternative source of energy for the generation of heat energy at boiler houses. Gasification is one of the cheapest and environmentally friendly methods for processing organic wood waste and obtaining an additional source of energy. The process of gasification occurs when wood waste is heated to high temperatures in the presence of oxygen, which results in the generation of combustible gas. Producer gas should be used to save traditional energy sources in the generation of heat energy. This article discusses the design of the gasifier which is intended for utilization of wood waste from a wood-processing enterprise and the simultaneous generation of producer gas. Generted producer gas is used in a boiler-house of a wood-processing enterprise as an alternative source of energy for the preparation of the heating system coolant. The lower heat of generated producer gas combustion is established.
Authors and Affiliations
Olena Savchenko, Vasyl Zhelykh, Yurii Yurkevych, Khrystyna Kozak, Serhii Bahmet
Keywords
Related Articles
- EP ID EP308019
- DOI 10.23939/jeecs2018.01.027
- Views 77
- Downloads 0
Analysis of Exergy Efficiency and Ways of Energy Saving in Air Conditioning System for a Cleanroom
In modern technologies, which are related to energy transformation, namely in air conditioning systems, important places are occupied by equipment and processes, the objective estimation of value of its energy perfection...
Peculiarities of Non-Stationary Pressure Measurement in Real Time
Nowadays, industrial development creates new and more complex processes leading to emergence of specific conditions for use of sensors and therefore specific measurement tasks. These circumstances lead to new requirement...
Optimization of Gas Dynamical Subsystem of Transducers for Measurement of Gas Flow Temperature
The main types of errors which occur while measuring the temperature of gas flows, including flows of fuels, are determined by the conditions of thermal balance at the interaction of the sensor of the temperature transdu...
Controlled Switched Reluctance Motors with Energy Capacitor
One of the most simple in terms of construction, the most practically feasible and reliable motors is a switched motor with salient-pole stator, concentrated coils and its winding and toothed passive rotor. Such motor is...
Investigations on the Innovation Model of Exergy Effectiveness of Air Conditioning System for Operating Cleanrooms
The issue of fuel and energy saving is a top priority for energy technological systems (ETS) such as air conditioning systems (ACS). Thus, reduction of energy consumption for ACS requires optimization of these systems wh...