Electromechanical Model of Machine for Vibroabrasive Treatment of Machine Parts
Journal Title: Український журнал із машинобудування і матеріалознавства - Year 2015, Vol 1, Issue 1
Abstract
A lot of operations on trimming clean and finishing – stripping up treatment, first of all, removing of burrs, rounding and processing of borders, until recently time was carried out by hand, and hardly exposed to automation and became a serious obstacle in subsequent growth of the labor productivity. Machines with free kinematics connection between a tool and the treating parts is provided by the printing-down of all of the surface of the machine parts, that allows us to effectively treat both internal and external surfaces of the machine parts. The analysis of literary sources, patents and charts of methods of the intensification of the processes of vibro abrasive treatment, allowed us to determine the basic directions of development of vibro machines constructions for intensification of the trimming - stripping of the machine parts in a freely granular environment in default of hard kinematic connection between the parts and the tool. The feature of vibro abrasive treatment is a free kinematic connection between a tool and the machine parts, i.e. there exists complication in providing with the stable beforehand set technologically optimum influence of abrasive grains on treated parts under variable parameters of the working chamber of vibroabrasive machine. The purpose of this work is the development of a structural electromechanical model of a vibromachine for adaptive vibroabrasive treatment of the machine parts. To solve this problem, the structural electromechanical model of vibromachine for adaptive vibroabrasive treatment of machine parts was developed. The offered machine is able to provide minimum energy consumption on the vibrodrive of vibroabrasive machine due to providing and maintenance of the permanent resonance mode of operations of working chamber.
Authors and Affiliations
Ruslan Gorbatiyk, Igor Palamarchuk, Roman Chubyk
Keywords
Related Articles
- EP ID EP200626
- DOI -
- Views 123
- Downloads 0
Development of Welding Consumables for Wet Underwater Welding of High-Alloy Corrosion-resistant Steel
This paper discusses a technology of mechanized wet underwater welding of high-alloy corrosion-resistance steel. The main aim of the investigation is development of self-shielded flux-cored wire for wet underwater weldin...
Two-mass Vibrating Conveyer with Nonparallel Flat Springs
The analysis of operation of vibrating conveyers with nonparallel placement of flat springs is carried out. The motion of mechanical oscillating system is investigated. The structure of the supporting unit for flat sprin...
Prospects of Use of Vibratory Devices with Electromagnetic Drives for Massive Piece Goods Conveying
Vibratory conveying devices with electromagnetic drive are widely used in the different branches of industry. As a rule, they deal with relatively small piece goods and are not suitable for conveying of the large massive...
Regulation of the phase-structural composition and metastability of austenite by alloying elements and parameters of tempering for increase wear-resistance of Fe-Cr-Mn deposited steel
It is shown that under the influence of alloying (Cr, Mn, C, Si, Ti, N, V) during electric arc hardfacing with a flux cored wire, as well as technological tempering parameters at temperatures of 300...700°C, the phase-st...
Corrosion-mechanical resistance of arc-sprayed coatings made from cored powders
Result of investigations of resistance against corrosion and mechanical resistance of obtained by means of arc-spray metallization (with the use of cored wires) coatings are presented. The cored wires (CWs) enable us to...