nfluence of Induction Hardening on Wear Resistance in Case of Rolling Contact
Journal Title: Strojnicky casopis - Journal of Mechanical Engineering - Year 2016, Vol 66, Issue 1
Abstract
The main aim of the presented paper is to show how heat treatment, in our case the induction hardening, will affect the wear rates as well as the ratcheting evolution process beneath the contact surface in the field of line rolling contact. Used wear model is based on shear band cracking mechanism [1] and non-linear kinematic and isotropic hardening rule of Chaboche and Lemaitre. The entire numerical simulations have been realized in the C# programming language. Results from numerical simulations are subsequently compared with experimental data.
Authors and Affiliations
Michal Šofer, Rostislav Fajkoš and Radim Halama
Keywords
Related Articles
- EP ID EP43879
- DOI https://doi.org/10.1515/scjme-2016-0007
- Views 264
- Downloads 0
Buckling Analysis of Hetero-Junction Carbon Nanotubes
The buckling analysis of carbon nanotubes without and with hetero-junctions is described in this paper. The buckling behaviour was investigated by the finite element method and the carbon nanotubes were modelled as spa...
Effect of Tapered Interference Fit between Impeller and Shaft in Turbo Machines
In Turbo machines, there are many components which are provided with interference to transmit torque and to maintain contact between them. There are transient scenarios where impeller and shaft lose interference and li...
The Calculation of the Contact Force and the Contact Width of Shaft Seals
The aim of the article is to point out the sealing efficiency of the two-language seal of the water pump bearing when radially deflecting the shaft within radial clearance. In order to obtain a radial displacement of th...
Studies on Improvement of Performance of Compression Ignition Engine Fuelled with Mixture of Honge Biodiesel and Tire Pyrolysis Oil
The biodiesel has lower volatility and is costlier than the fossil diesel. Hence it is necessary to add a low cost fuel which has higher volatility, with the diesel. The tire pyrolysis oil (TPO) produced from waste tire...
Vehicle Speed Determination in Case of Road Accident by Software Method and Comparing of Results with the Mathematical Model
The paper addresses the problem to vehicle speed calculation at road accidents. To determine the speed are used the PC Crash software and Virtual Crash. With both methods are analysed concrete cases of road accidents....