ВИРОБНИЦТВО, ВЛАСТИВОСТІ І ЗАСТОСУВАННЯ ГАЗОБЕТОНУ НЕАВТОКЛАВНОГО ТВЕРДНЕННЯ
Journal Title: Вісник Національного університету "Львівська політехніка". Серія "Теорія та практика будівництва" - Year 2017, Vol 0, Issue 877
Abstract
One of the priorities of modern construction industry is to increase the heat-shielding properties enclosing structures and reduce construction costs. Solving these problems is possible through the use in the manufacture of insulating exterior walling and structuralinsulating non-autoclaved aerated concrete from technogenic waste, especially fly ahes and slag thermal power plants. The development of aerated concrete deserves special attention, which is due to the relative simplicity of manufacturing techniques compared to nonautoclaved aerated concrete with porous concrete autoclaved and traditional building materials; metal consumption relatively lower power consumption and equipment for its production. Aerated concrete is the optimal material for building because it has wide density and durability ranges, the properties being important for solving various construction problems. The increased production of non-autoclaved aerated concretes is caused by the increasing demand of residential building. In the article compared the properties of nonautoclaved aerated concrete, obtained by traditional technology and finished dry mixture, the effects of chemical additives on the characteristics of non-autoclaved aerated concrete are shown. The use of chemical additives MCTF 12 allows to obtain non-autoclaved aerated concrete with average density of 500 kg/m3, the compressive strength 2,2 MPa and the estimated coefficient of thermal conductivity of 0,16W / (mK).
Authors and Affiliations
O. Pozniak, V. Melnyk, I. Zavadskyy, A. Melnyk
Keywords
Related Articles
- EP ID EP284762
- DOI -
- Views 128
- Downloads 0
ВПЛИВ ЗНАЧЕННЯ КУТІВ ПРИЄДНАННЯ ВХІДНИХ СТРУМЕНІВ НА НЕРІВНОМІРНІСТЬШЛЯХОВОГО ПРИТОКУ ВОДИ ДО НАПІРНОГО ТРУБОПРОВОДУ-ЗБИРАЧА
Results of the experimental investigation of water inflow into a pressure pipe-collector (PC) depending on the value of the inflow angle b of the input jets are presented. The inner diameter of the experimental PC was of...
Розрахунок за деформаційною моделлю залізобетонних колон, підсилених вуглецевою стрічкою
In this paper for calculation of reinforced concrete columns strengthened with carbon laminate with suggestions based on the method of calculation according to the recommendations NIISK and Sika on the basis of deformati...
Аналіз сучасного досвіду проектування будівель із застосуванням трубобетоних елементів
The thesis is devoted to the analysis of existent constructive forms of joint of concrete filled tube columns to various types of ceilings, their advantages and disadvantages. The actual tendencies, which react on introd...
ВПЛИВ СЕЙСМІЧНИХ ДІЙ НА ЗБІРНІ ЗАЛІЗОБЕТОННІ КОНСТРУКЦІЇ ПОКРИТТЯ ВИРОБНИЧОЇ БУДІВЛІ У м. УЖГОРОД
The need for strengthening of precast concrete structures in service occurs not only in reconstruction cases because of their physical deterioration but also as a result of seismic effects. In seismic regions (Uzhgorod b...
A METHODOLOGY OF MODELLING THE STRESS-STRAIN STATE OF RIGID CONNECTION JOINTS OF SITECAST REINFORCED CONCRETE CEILING TO CONCRETE FILLED TUBE COLUMN
The methodology of modeling the stress-strain state of rigid connection joints of sitecast reinforced concrete ceiling to concrete-filled column was developed. The construction of ceiling include the external steel reinf...