FRICTION PROCESSES OF SELECTED POLYMERS SLIDING ON STEEL AND DURALUMIN IN A LUBRICANT ENVIRONMENT
Journal Title: Tribologia - Year 2016, Vol 268, Issue 4
Abstract
The article presents the results of tribological research into engineering polymers (POM, PEEK, PPS) cooperating in sliding motion with 316L steel and EN AW-2017A aluminium alloy in the presence of a liquid (water, hydraulic oil HLP68). This type of friction pair may occur in hydraulic systems (gear pumps, valves, etc.). For comparison, additionally, the results of tribological research carried out in dry friction conditions have been shown. In addition, the results of microscopic study of the sliding surfaces of polymeric materials have been presented. Analysis of the test results allows one to describe the processes of friction and wear of the studied sliding pairs.<br/><br/>
Authors and Affiliations
Wojciech WIELEBA, Tadeusz LEŚNIEWSKI, Darhan ELEMES, Ainur ELEMES
Keywords
Related Articles
- EP ID EP244284
- DOI 10.5604/01.3001.0010.6995
- Views 49
- Downloads 0
CATIONIC POLYMERS AS EFFECTIVE WATER-BASED LUBRICANT ADDITIVES
Studies on water as a lubricant base are being carried out primarily because of ecological considerations. Attempts are being made to improve its unfavourable tribological and physicochemical properties (e.g. corrosive a...
RESEARCH ON STRUCTURES AND WEAR PROCESSES OF HARD SURFACE LAYERS IN A SOIL ABRASIVE MASS
The paper presents the analysis of the process of the wear, using the unit wear rate, of hard surface layers with different structures in a gravel and loamy abrasive soil mass in two states of moisture, dry and wet. Test...
CHOSEN TRIBOLOGICAL PROPERTIES OF FeAl ALLOYS
This research was focused on tribological properties of FeAl alloys. Powder and cast FeAl alloy was used in this study. The influence of the alloy morphology on its tribological properties is discussed. Tribological test...
Stanowisko do badania statycznego i kinetycznego współczynnika tarcia skojarzeń ciernych
W artykule przedstawiono zbudowane stanowisko do badania procesów tarcia skojarzeń ciernych, stosowanych w konstrukcjach sprzęgieł i hamulców. Praca zawiera schemat i opis działania stanowiska oraz zaprojektowanych toró...
TEMPERATURE OF PLOUGHSHARE MATERIAL IN THE COURSE OF PLOUGHING
The change of temperature of subsurface layer material of ploughshare, occurring in the course of fine sandy loam (8% moisture and temperature 15.3°C) cultivation, done with bed making plough, was determined. Measuring s...